AD Amdt-39-11928

[Federal Register Volume 65, Number 200 (Monday, October 16, 2000)]
[Rules and Regulations]
[Pages 61083-61085]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 00-26092]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-312-AD; Amendment 39-11928; AD 2000-20-03 R1]
RIN 2120-AA64


Airworthiness Directives; Bombardier Model CL-600-2B19 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: This amendment revises an existing airworthiness directive 
(AD), applicable to certain Bombardier Model CL-600-2B19 series 
airplanes, that currently requires installation of shields for the 
aileron quadrants in the wheel bay of the main landing gear (MLG). This 
amendment revises the compliance time for the requirements of that AD. 
The actions specified in this AD are intended to prevent accumulation 
of

[[Page 61084]]

water, ice, or slush on the aileron quadrants and control cable pulleys 
in the wheel bay of the MLG, which could freeze and result in reduced 
controllability of the airplane.

DATES: Effective October 2, 2000.
    The incorporation by reference of certain publications listed in 
the regulations was approved previously by the Director of the Federal 
Register as of October 2, 2000 (65 FR 57944, September 27, 2000).
    Comments for inclusion in the Rules Docket must be received on or 
before October 23, 2000.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 2000-NM-312-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9 a.m. and 3 p.m., Monday through Friday, except 
Federal holidays. Comments may be submitted via fax to (425) 227-1232. 
Comments may also be sent via the Internet using the following address: 
<a href="/cdn-cgi/l/email-protection#cff6e2aea1a2e2a6aebdaca0a2a2aaa1bb8fa9aeaee1a8a0b9"><span class="__cf_email__" data-cfemail="bd8490dcd3d090d4dccfded2d0d0d8d3c9fddbdcdc93dad2cb">[email&#160;protected]</span></a>. Comments sent via fax or the Internet must 
contain ``Docket No. 2000-NM-312-AD'' in the subject line and need not 
be submitted in triplicate. Comments sent via the Internet as attached 
electronic files must be formatted in Microsoft Word 97 for Windows or 
ASCII text.
    The service information referenced in this AD may be obtained from 
Bombardier, Inc., Canadair, Aerospace Group, P.O. Box 6087, Station 
Centre-ville, Montreal, Quebec H3C 3G9, Canada. This information may be 
examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, 
SW., Renton, Washington; or at the FAA, New York Aircraft Certification 
Office, 10 Fifth Street, Third Floor, Valley Stream, New York; or at 
the Office of the Federal Register, 800 North Capitol Street, NW., 
suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Daniel Parrillo, Aerospace Engineer, 
Airframe and Propulsion Branch, ANE-172, FAA, New York Aircraft 
Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New 
York 11581; telephone (516) 256-7505; fax (516) 568-2716.

SUPPLEMENTARY INFORMATION: On September 22, 2000, the FAA issued AD 
2000-20-03, amendment 39-11914 (65 FR 57944, September 27, 2000), 
applicable to certain Bombardier Model CL-600-2B19 series airplanes, to 
require installation of shields for the aileron quadrants and control 
cable pulleys in the wheel bay of the main landing gear (MLG). The 
actions required by that AD are intended to prevent accumulation of 
water, ice, or slush on the aileron quadrants and control cable pulleys 
in the wheel bay of the MLG, which could freeze and result in reduced 
controllability of the airplane.

Actions Since Issuance of Previous Rule

    Since the issuance of that AD, the FAA has determined that an 
incorrect compliance time for the installation of the shields was 
inadvertently specified in AD 2000-20-03. Instead of ``within 30 days 
after the effective date of this AD,'' the compliance time should read 
``within 45 days after the effective date of this AD.''

FAA's Findings

    This airplane model is manufactured in Canada and is type 
certificated for operation in the United States under the provisions of 
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and 
the applicable bilateral airworthiness agreement. Pursuant to this 
bilateral airworthiness agreement, Transport Canada Civil Aviation 
(TCAA) has kept the FAA informed of the situation described above. The 
FAA has examined the findings of the TCAA, reviewed all available 
information, and determined that AD action is necessary for products of 
this type design that are certificated for operation in the United 
States.

Explanation of Requirements of Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, this AD revises AD 2000-20-03 to require 
installation of shields for the aileron quadrants in the wheel bay of 
the MLG within 45 days after October 2, 2000 (the effective date of AD 
2000-20-03).

Determination of Rule's Effective Date

    Since a situation still exists that requires the immediate adoption 
of this regulation, it is found that notice and opportunity for prior 
public comment hereon are impracticable, and that good cause still 
exists for making this amendment effective in less than 30 days.

Comments Invited

    Although this action is in the form of a final rule that involves 
requirements affecting flight safety and, thus, was not preceded by 
notice and an opportunity for public comment, comments are invited on 
this rule. Interested persons are invited to comment on this rule by 
submitting such written data, views, or arguments as they may desire. 
Communications shall identify the Rules Docket number and be submitted 
in triplicate to the address specified under the caption ADDRESSES. All 
communications received on or before the closing date for comments will 
be considered, and this rule may be amended in light of the comments 
received. Factual information that supports the commenter's ideas and 
suggestions is extremely helpful in evaluating the effectiveness of the 
AD action and determining whether additional rulemaking action would be 
needed.
    Submit comments using the following format:
    <bullet> Organize comments issue-by-issue. For example, discuss a 
request to change the compliance time and a request to change the 
service bulletin reference as two separate issues.
    <bullet> For each issue, state what specific change to the AD is 
being requested.
    <bullet> Include justification (e.g., reasons or data) for each 
request.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the rule that might 
suggest a need to modify the rule. All comments submitted will be 
available, both before and after the closing date for comments, in the 
Rules Docket for examination by interested persons. A report that 
summarizes each FAA-public contact concerned with the substance of this 
AD will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this rule must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 2000-NM-312-AD.'' The postcard will be date stamped 
and returned to the commenter.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    The FAA has determined that this regulation is an emergency 
regulation that must be issued immediately to correct an unsafe 
condition in aircraft, and that it is not a ``significant regulatory 
action'' under Executive Order 12866. It has been determined

[[Page 61085]]

further that this action involves an emergency regulation under DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979). If 
it is determined that this emergency regulation otherwise would be 
significant under DOT Regulatory Policies and Procedures, a final 
regulatory evaluation will be prepared and placed in the Rules Docket. 
A copy of it, if filed, may be obtained from the Rules Docket at the 
location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by removing amendment 39-11914 (65 FR 
57944, September 27, 2000), and by adding a new airworthiness directive 
(AD), amendment 39-11928, to read as follows:

2000-20-03 R1  Bombardier, Inc. (Formerly Canadair): Amendment 39-
11928. Docket 2000-NM-312-AD. Revises AD 2000-20-03, Amendment 39-
11914.

    Applicability: Model CL-600-2B19 series airplanes, serial 
numbers 7003 through 7323 inclusive, certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent reduced controllability of the airplane due to an 
accumulation of water, ice, and slush on the aileron quadrants and 
control cable pulleys in the wheel bay of the main landing gear 
(MLG); accomplish the following:

Installation

    (a) Within 45 days after October 2, 2000 (the effective date of 
AD 2000-20-03), install splash shields in the wheel bay of the MLG 
in accordance with Bombardier Service Bulletin 601R-27-104, dated 
October 15, 1999.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, New York Aircraft Certification 
Office (ACO), FAA. Operators shall submit their requests through an 
appropriate FAA Principal Maintenance Inspector, who may add 
comments and then send it to the Manager, New York ACO.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the New York ACO.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The installation shall be done in accordance with Bombardier 
Service Bulletin 601R-27-104, dated October 15, 1999. This 
incorporation by reference was approved previously by the Director 
of the Federal Register as of October 2, 2000 (65 FR 57944, 
September 27, 2000). Copies may be obtained from Bombardier Inc., 
Canadair, Aerospace Group, P.O. Box 6087, Station Centre-ville, 
Montreal, Quebec H3C 3G9, Canada. Copies may be inspected at the 
FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington; or at the FAA, New York Aircraft Certification Office, 
10 Fifth Street, Third Floor, Valley Stream, New York 11581; or at 
the Office of the Federal Register, 800 North Capitol Street, NW., 
suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in Canadian 
airworthiness directive CF-2000-28, dated August 28, 2000.

Effective Date

    (e) This amendment becomes effective on October 2, 2000.

    Issued in Renton, Washington, on October 4, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-26092 Filed 10-13-00; 8:45 am]
BILLING CODE 4910-13-P