AD Amdt-39-10848

[Federal Register Volume 63, Number 204 (Thursday, October 22, 1998)]
[Rules and Regulations]
[Pages 56541-56542]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-28156]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-191-AD; Amendment 39-10848; AD 98-22-02]
RIN 2120-AA64


Airworthiness Directives; Saab Model SAAB 2000 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Saab Model SAAB 2000 series airplanes, that 
requires replacement of the outboard trunnion pin of the shock strut on 
the main landing gear (MLG) with a new and improved outboard trunnion 
pin. This amendment is prompted by issuance of mandatory continuing 
airworthiness information by a foreign civil airworthiness authority. 
The actions specified by this AD are intended to prevent failure of the 
outboard trunnion pin due to fatigue cracking, which could result in 
collapse of the MLG.

DATES: Effective November 27, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of November 27, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Saab Model SAAB 2000 
series airplanes was published in the Federal Register on August 26, 
1998 (63 FR 45421). That action proposed to require replacement of the 
outboard trunnion pin of the shock strut on the main landing gear (MLG) 
with a new and improved outboard trunnion pin.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 3 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 2 work hours per 
airplane to accomplish the required replacement, and that the average 
labor rate is $60 per work hour. Required parts will be supplied by the 
manufacturer at no cost to the operators. Based on these figures, the 
cost impact of the replacement required by this AD on U.S. operators is 
estimated to be $360, or $120 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic

[[Page 56542]]

impact, positive or negative, on a substantial number of small entities 
under the criteria of the Regulatory Flexibility Act. A final 
evaluation has been prepared for this action and it is contained in the 
Rules Docket. A copy of it may be obtained from the Rules Docket at the 
location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-22-02  SAAB Aircraft AB: Amendment 39-10848. Docket 98-NM-191-AD.

    Applicability: Model SAAB 2000 series airplanes, serial numbers 
-002 through -050 inclusive, -052, and -053; certificated in any 
category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (c) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the outboard trunnion pin due to fatigue 
cracking, which could result in collapse of the main landing gear 
(MLG), accomplish the following:
    (a) Prior to the accumulation of 8,200 total landings, or within 
60 days after the effective date of this AD, whichever occurs later, 
replace the outboard trunnion pin of the shock strut on the MLG with 
a new and improved outboard trunnion pin, in accordance with Saab 
Service Bulletin 2000-32-042, dated March 27, 1998, including 
Attachments 1 and 2, dated June 1997.
    (b) As of the effective date of this AD, no person shall install 
on any airplane an outboard trunnion pin having part number (P/N) 
AIR132900 or AIR134608.
    (c) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (d) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (e) The replacement shall be done in accordance with SAAB 
Service Bulletin 2000-32-042, dated March 27, 1998, including 
Attachments 1 and 2, dated June 1997, which contains the following 
list of effective pages:

------------------------------------------------------------------------
                                  Revision level
          Page number             shown on page     Date shown on page
------------------------------------------------------------------------
1-3............................  Original.......  March 27, 1998.
------------------------------------------------------------------------
                              Attachment 1
------------------------------------------------------------------------
1-4............................  1..............  June 1997.
------------------------------------------------------------------------
                              Attachment 2
------------------------------------------------------------------------
1-4............................  2..............  June 1997.
------------------------------------------------------------------------

    This incorporation by reference was approved by the Director of 
the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR 
part 51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft 
Product Support, S-581.88, Linkoping, Sweden. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in Swedish 
airworthiness directive 1-123, dated March 30, 1998.

    (f) This amendment becomes effective on November 27, 1998.

    Issued in Renton, Washington, on October 14, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-28156 Filed 10-21-98; 8:45 am]
BILLING CODE 4910-13-U