AD Amdt-39-10661

[Federal Register Volume 63, Number 136 (Thursday, July 16, 1998)]
[Rules and Regulations]
[Pages 38284-38285]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-18774]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-117-AD; Amendment 39-10661; AD 98-15-10]
RIN 2120-AA64


Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B 
Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Saab Model SAAB SF340A and SAAB 340B series 
airplanes, that requires modification of the detachable center inlet 
component of the air intake system of the engine. This amendment is 
prompted by issuance of mandatory continuing airworthiness information 
by a foreign civil airworthiness authority. The actions specified by 
this AD are intended to prevent fuel and/or oil that may be present in 
the nacelle from entering the air intake system of the engine, which 
could result in a possible engine fire.

DATES: Effective August 20, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of August 20, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-
581.88, Linkoping, Sweden. This information may be examined at the 
Federal Aviation

[[Page 38285]]

Administration (FAA), Transport Airplane Directorate, Rules Docket, 
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, Washington, 
DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Saab Model SAAB SF340A and 
SAAB 340B series airplanes was published in the Federal Register on May 
20, 1998 (63 FR 27694). That action proposed to require modification of 
the detachable center inlet component of the air intake system of the 
engine.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 135 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 2 work hours per 
airplane to accomplish the required modification, and that the average 
labor rate is $60 per work hour. Required parts will be provided by the 
manufacturer at no cost to the operators. Based on these figures, the 
cost impact of the AD on U.S. operators is estimated to be $16,200, or 
$120 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-15-10  SAAB Aircraft AB (Formerly SAAB Fairchild): Amendment 39-
10661. Docket 98-NM-117-AD.

    Applicability: Model SAAB SF340A and Model SAAB 340B series 
airplanes, as listed in SAAB Service Bulletin 340-30-073, dated 
August 18, 1997; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent fuel and/or oil that may be present in the nacelle 
from entering the air intake system of the engine, which could 
result in a possible engine fire, accomplish the following:
    (a) Within 2 years after the effective date of this AD, modify 
the detachable center inlet component of the air intake system of 
the engine, in accordance with Saab Service Bulletin 340-30-073, 
dated August 18, 1997, including Attachment 1, dated March 6, 1997.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The modification shall be done in accordance with SAAB 
Service Bulletin 340-30-073, dated August 18, 1997, including 
Attachment 1, dated March 6, 1997. This incorporation by reference 
was approved by the Director of the Federal Register in accordance 
with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from 
Saab Aircraft AB, SAAB Aircraft Product Support, S-581.88, 
Linkoping, Sweden. Copies may be inspected at the FAA, Transport 
Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or 
at the Office of the Federal Register, 800 North Capitol Street, 
NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in Swedish 
airworthiness directive 1-119, dated August 21, 1997.

    (e) This amendment becomes effective on August 20, 1998.

    Issued in Renton, Washington, on July 8, 1998.
S.R. Miller,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-18774 Filed 7-15-98; 8:45 am]
BILLING CODE 4910-13-U