AD Amdt-39-10324

[Federal Register Volume 63, Number 31 (Tuesday, February 17, 1998)]
[Rules and Regulations]
[Pages 7639-7640]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-3259]



========================================================================
Rules and Regulations
                                                Federal Register
________________________________________________________________________

This section of the FEDERAL REGISTER contains regulatory documents 
having general applicability and legal effect, most of which are keyed 
to and codified in the Code of Federal Regulations, which is published 
under 50 titles pursuant to 44 U.S.C. 1510.

The Code of Federal Regulations is sold by the Superintendent of Documents. 
Prices of new books are listed in the first FEDERAL REGISTER issue of each 
week.

========================================================================


Federal Register / Vol. 63, No. 31 / Tuesday, February 17, 1998 / 
Rules and Regulations

[[Page 7639]]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-150-AD; Amendment 39-10324; AD 98-04-11]
RIN 2120-AA64


Airworthiness Directives; Airbus Model A320 and A321 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Airbus Model A320 and A321 series airplanes, that 
requires activation of a spoiler function that allows partial ground 
spoiler activation with only one main landing gear compressed. This 
amendment is prompted by issuance of mandatory continuing airworthiness 
information by a foreign civil airworthiness authority. The actions 
specified by this AD are intended to prevent possible delays in 
deceleration when landing with strong cross winds and/or on a 
contaminated runway, which could increase the potential for landing 
overrun.

DATES: Effective March 24, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of March 24, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 
Blagnac Cedex, France. This information may be examined at the Federal 
Aviation Administration (FAA), Transport Airplane Directorate, Rules 
Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of 
the Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Airbus Model A320 and A321 
series airplanes was published in the Federal Register on December 11, 
1997 (62 FR 65227). That action proposed to require activation of a 
spoiler function that allows partial ground spoiler activation with 
only one main landing gear compressed.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the comments received.
    Several commenters support the proposed rule.

Conclusion

    After careful review of the available data, including the comments 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 132 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 17 work hours per 
airplane to accomplish the required actions, and that the average labor 
rate is $60 per work hour. Required parts will be provided by the 
manufacturer at no cost to operators. Based on these figures, the cost 
impact of the AD on U.S. operators is estimated to be $134,640, or 
$1,020 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-04-11 Airbus: Amendment 39-10324. Docket 97-NM-150-AD.

    Applicability: Model A320 and A321 series airplanes on which 
Airbus Modification No. 24745 (Airbus Service Bulletin A320-27-1088, 
Revision 3, dated December 11, 1996) has not been accomplished, 
certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance

[[Page 7640]]

of the requirements of this AD is affected, the owner/operator must 
request approval for an alternative method of compliance in 
accordance with paragraph (b) of this AD. The request should include 
an assessment of the effect of the modification, alteration, or 
repair on the unsafe condition addressed by this AD; and, if the 
unsafe condition has not been eliminated, the request should include 
specific proposed actions to address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent possible delays in deceleration when landing with 
strong cross winds and/or on a contaminated runway, which could 
increase the potential for landing overrun, accomplish the 
following:
    (a) Within 12 months after the effective date of this AD, 
activate the spoiler ``phased lift dumping'' function by modifying 
the aircraft wiring at the level of the three spoiler elevator 
computer (SEC) connectors, in accordance with Airbus Service 
Bulletin A320-27-1088, Revision 03, dated December 11, 1996.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from theInternational Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The actions shall be done in accordance with Airbus Service 
Bulletin A320-27-1088, Revision 03, dated December 11, 1996. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from Airbus Industrie, 1 Rond Point 
Maurice Bellonte, 31707 Blagnac Cedex, France. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in French 
airworthiness directive 96-169-081(B), dated August 28, 1996.

    (e) This amendment becomes effective on March 24, 1998.

    Issued in Renton, Washington, on February 4, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-3259 Filed 2-13-98; 8:45 am]
BILLING CODE 4910-13-U