AD 2005-20-14
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | Airbus | A300 B4-620 | Airworthiness Directives; Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 Airplanes |
| aircraft | Airbus | A310-304 | Airworthiness Directives; Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 Airplanes |
| aircraft | Airbus | A310-324 | Airworthiness Directives; Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 Airplanes |
| aircraft | Airbus | A310-325 | Airworthiness Directives; Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 Airplanes |
Unsafe Condition
An ignition source in the auxiliary center tank (ACT), in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Install fused adaptors between the external wiring harness and the in-tank wiring at the connectors on the fuel tank wall of the ACT, as specified in the applicable Airbus service bulletin.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
Within 24 months after the effective date of the AD (November 10, 2005).
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 airplanes, certificated in any category, equipped with one or more auxiliary center tank (ACT), except those on which Airbus Modification 12471 has been accomplished in production.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Model A300 B4-620, A310-304, A310-324, and A310-325 airplanes. This AD requires installing fused adaptors between the external wiring harness and the in-tank wiring at the connectors on the fuel tank wall of the auxiliary center tank (ACT). This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent an ignition source in the ACT, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
Document Text
Show stored source text (verify against official source)
[Federal Register Volume 70, Number 193 (Thursday, October 6, 2005)]
[Rules and Regulations]
[Pages 58303-58304]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 05-19844]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. FAA-2005-22032; Directorate Identifier 2005-NM-049-AD;
Amendment 39-14308; AD 2005-20-14]
RIN 2120-AA64
Airworthiness Directives; Airbus Model A300 B4-620, A310-304,
A310-324, and A310-325 Airplanes
AGENCY: Federal Aviation Administration (FAA), Department of
Transportation (DOT).
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: The FAA is adopting a new airworthiness directive (AD) for
certain Airbus Model A300 B4-620, A310-304, A310-324, and A310-325
airplanes. This AD requires installing fused adaptors between the
external wiring harness and the in-tank wiring at the connectors on the
fuel tank wall of the auxiliary center tank (ACT). This AD results from
fuel system reviews conducted by the manufacturer. We are issuing this
AD to prevent an ignition source in the ACT, which, in combination with
flammable fuel vapors, could result in a fuel tank explosion and
consequent loss of the airplane.
DATES: This AD becomes effective November 10, 2005.
The Director of the Federal Register approved the incorporation by
reference of certain publications listed in the AD as of November 10,
2005.
ADDRESSES: You may examine the AD docket on the Internet at <a href="http://dms.dot.gov">http://dms.dot.gov</a> or in person at the Docket Management Facility, U.S.
Department of Transportation, 400 Seventh Street SW., Nassif Building,
room PL-401, Washington, DC.
Contact Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex,
France, for service information identified in this AD.
FOR FURTHER INFORMATION CONTACT: Tim Backman, Aerospace Engineer,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2797; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION:
Examining the Docket
You may examine the airworthiness directive (AD) docket on the
Internet at <a href="http://dms.dot.gov">http://dms.dot.gov</a> or in person at the Docket Management
Facility office between 9 a.m. and 5 p.m., Monday through Friday,
except Federal holidays. The Docket Management Facility office
(telephone (800) 647-5227) is located on the plaza level of the Nassif
Building at the street address stated in the ADDRESSES section.
Discussion
The FAA issued a notice of proposed rulemaking (NPRM) to amend 14
CFR part 39 to include an AD that would apply to certain Airbus Model
A300 B4-620, A310-304, A310-324, and A310-325 airplanes. That NPRM was
published in the Federal Register on August 8, 2005 (70 FR 45587). That
NPRM proposed to require installing fused adaptors between the external
wiring harness and the in-tank wiring at the connectors on the fuel
tank wall of the auxiliary center tank (ACT).
Comments
We provided the public the opportunity to participate in the
development of this AD. We received no comments on the NPRM or on the
determination of the cost to the public.
Clarification of Alternative Method of Compliance (AMOC) Paragraph
We have revised this AD to clarify the appropriate procedure for
notifying the principal inspector before using any approved AMOC on any
airplane to which the AMOC applies.
Conclusion
We have carefully reviewed the available data and determined that
air safety and the public interest require adopting the AD with the
change described previously. We have determined that this change will
neither increase the economic burden on any operator nor increase the
scope of the AD.
Costs of Compliance
This AD affects about 2 airplanes of U.S. registry. The actions
take about 52 work hours per airplane, at an average labor rate of $65
per work hour. Required parts cost about $5,410 per ACT (up to two ACTs
per airplane). Based on these figures, the estimated cost of the AD for
U.S. operators is $8,790 per ACT, per airplane.
Currently, there are no Model A300 B4-620 airplanes of U.S.
registry with one or more ACTs. However, if an affected airplane is
imported and placed on the U.S. Register in the future, the required
actions would take about 52 work hours, at an average labor rate of $65
per work hour. Required parts would cost about $10,730 per ACT, per
airplane. Based on these figures, we
[[Page 58304]]
estimate the cost of this AD to be $14,110 per ACT.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to
issue rules on aviation safety. Subtitle I, section 106, describes the
authority of the FAA Administrator. Subtitle VII, Aviation Programs,
describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in
subtitle VII, part A, subpart III, section 44701, ``General
requirements.'' Under that section, Congress charges the FAA with
promoting safe flight of civil aircraft in air commerce by prescribing
regulations for practices, methods, and procedures the Administrator
finds necessary for safety in air commerce. This regulation is within
the scope of that authority because it addresses an unsafe condition
that is likely to exist or develop on products identified in this
rulemaking action.
Regulatory Findings
We have determined that this AD will not have federalism
implications under Executive Order 13132. This AD will not have a
substantial direct effect on the States, on the relationship between
the national government and the States, or on the distribution of power
and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
(1) Is not a ``significant regulatory action'' under Executive
Order 12866;
(2) Is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and
(3) Will not have a significant economic impact, positive or
negative, on a substantial number of small entities under the criteria
of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to
comply with this AD and placed it in the AD docket. See the ADDRESSES
section for a location to examine the regulatory evaluation.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
0
Accordingly, under the authority delegated to me by the Administrator,
the FAA amends 14 CFR part 39 as follows:
PART 39--AIRWORTHINESS DIRECTIVES
0
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
0
2. The Federal Aviation Administration (FAA) amends Sec. 39.13 by
adding the following new airworthiness directive (AD):
2005-20-14 Airbus: Amendment 39-14308. Docket No. FAA-2005-22032;
Directorate Identifier 2005-NM-049-AD.
Effective Date
(a) This AD becomes effective November 10, 2005.
Affected ADs
(b) None.
Applicability
(c) This AD applies to Airbus Model A300 B4-620, A310-304, A310-
324, and A310-325 airplanes, certificated in any category; equipped
with one or more auxiliary center tank (ACT), except those on which
Airbus Modification 12471 has been accomplished in production.
Unsafe Condition
(d) This AD is prompted by the results of fuel system reviews
conducted by the manufacturer. We are issuing this AD to prevent an
ignition source in the ACT, which, in combination with flammable
fuel vapors, could result in a fuel tank explosion and consequent
loss of the airplane.
Compliance
(e) You are responsible for having the actions required by this
AD performed within the compliance times specified, unless the
actions have already been done.
Modification
(f) Within 24 months after the effective date of this AD:
Install fused adaptors between the external wiring harness and the
in-tank wiring at the connectors on the fuel tank wall of the ACT by
doing all the actions specified in the Accomplishment Instructions
of the applicable service bulletin in Table 1 of this AD.
Table 1.--Airbus Service Bulletins
------------------------------------------------------------------------
Airbus Service Bulletin Date Model
------------------------------------------------------------------------
A300-28-6073.................. December 23, 2004 A300 B4-620
airplanes.
A310-28-2149.................. September 29, A310-304, A310-324,
2004. and A310-325
airplanes.
------------------------------------------------------------------------
Alternative Methods of Compliance (AMOCs)
(g)(1) The Manager, ANM-116, Transport Airplane Directorate,
FAA, has the authority to approve AMOCs for this AD, if requested in
accordance with the procedures found in 14 CFR 39.19.
(2) Before using any AMOC approved in accordance with Sec.
39.19 on any airplane to which the AMOC applies, notify the
appropriate principal inspector in the FAA Flight Standards
Certificate Holding District Office.
Related Information
(h) French airworthiness directive F-2005-021, dated February 2,
2005, also addresses the subject of this AD.
Material Incorporated by Reference
(i) You must use Airbus Service Bulletin A300-28-6073, dated
December 23, 2004; or Airbus Service Bulletin A310-28-2149, dated
September 29, 2004; as applicable, to perform the actions that are
required by this AD, unless the AD specifies otherwise. The Director
of the Federal Register approved the incorporation by reference of
these documents in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Contact Airbus, 1 Rond Point Maurice Bellonte, 31707 Blagnac
Cedex, France, for a copy of this service information. You may
review copies at the Docket Management Facility, U.S. Department of
Transportation, 400 Seventh Street SW., room PL-401, Nassif
Building, Washington, DC; on the Internet at <a href="http://dms.dot.gov">http://dms.dot.gov</a>; or
at the National Archives and Records Administration (NARA). For
information on the availability of this material at the NARA, call
(202) 741-6030, or go to <a href="http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html">http://www.archives.gov/federal_register/code_of_federal_regulations/ibr_locations.html</a>.
Issued in Renton, Washington, on September 26, 2005.
Ali Bahrami,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 05-19844 Filed 10-5-05; 8:45 am]
BILLING CODE 4910-13-P
Source: Official FAA Source ↗
Retrieved: Apr 6, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.