AD Amdt-39-10601

[Federal Register Volume 63, Number 117 (Thursday, June 18, 1998)]
[Rules and Regulations]
[Pages 33243-33244]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-16054]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-71-AD; Amendment 39-10601; AD 98-13-13]
RIN 2120-AA64


Airworthiness Directives; Mitsubishi Heavy Industries Ltd. Model 
YS-11 and YS-11A Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all Mitsubishi Model YS-11 and YS-11A series airplanes. 
This amendment requires revising the Airplane Flight Manual (AFM) to 
prohibit positioning the power levers below the flight idle stop. This 
amendment is prompted by incidents and accidents involving airplanes 
equipped with turboprop engines in which the propeller beta was used 
improperly during flight. The actions specified by this AD are intended 
to prevent loss of airplane controllability or engine overspeed with 
consequent loss of engine power caused by the power levers being 
positioned below the flight idle stop while the airplane is in flight.

EFFECTIVE DATE: July 23, 1998.

ADDRESSES: Information pertaining to this amendment may be examined at 
the Federal Aviation Administration (FAA), Transport Airplane 
Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington.

FOR FURTHER INFORMATION CONTACT: Mark Quam, Aerospace Engineer, 
Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 
1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 
227-2145; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all Mitsubishi Model YS-11 and YS-
11A series airplanes was published in the Federal Register on April 9, 
1998 (63 FR 17346). That action proposed to require revising the 
Limitations Section of the Airplane Flight Manual (AFM) to prohibit the 
positioning of the power levers below the flight idle stop while the 
airplane is in flight, and to add a statement of the consequences of 
positioning the power

[[Page 33244]]

levers below the flight idle stop while the airplane is in flight.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.

Conclusion

    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Interim Action

    This is considered interim action until final action is identified, 
at which time the FAA may consider further rulemaking.

Cost Impact

    The FAA estimates that 10 Mitsubishi Model YS-11 and YS-11A series 
airplanes of U.S. registry will be affected by this AD, that it will 
take approximately 1 work hour per airplane to accomplish the required 
actions, and that the average labor rate is $60 per work hour. Based on 
these figures, the cost impact of the AD on U.S. operators is estimated 
to be $600, or $60 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-13-13  Mitsubishi Heavy Industries, Ltd. [Formerly Nihon 
Aeroplane Manufacturing Company (NMAC)]: Amendment 39-10601. Docket 
97-NM-71-AD.

    Applicability: All Model YS-11 and YS-11A -200, -300, -500, and 
-600 series airplanes; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of airplane controllability or engine overspeed 
with consequent loss of engine power caused by the power levers 
being positioned below the flight idle stop while the airplane is in 
flight, accomplish the following:
    (a) Within 30 days after the effective date of this AD, revise 
the Limitations Section of the FAA-approved Airplane Flight Manual 
(AFM) to include the following statements. This action may be 
accomplished by inserting a copy of this AD into the AFM.
    ``Warning: While the airplane is airborne, the LOW STOP lever 
(flight fine pitch stop) should not be placed in the GROUND position 
for any reason. Placing the LOW STOP lever in the GROUND position in 
flight may lead to loss of airplane control or may result in an 
engine overspeed condition and consequent loss of engine power.''
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Standardization Branch, ANM-113, 
FAA, Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Operations Inspector, 
who may add comments and then send it to the Manager, 
Standardization Branch, ANM-113.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Standardization Branch, ANM-113.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) This amendment becomes effective on July 23, 1998.

    Issued in Renton, Washington, on June 11, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-16054 Filed 6-17-98; 8:45 am]
BILLING CODE 4910-13-U