AD Amdt-39-10580

[Federal Register Volume 63, Number 111 (Wednesday, June 10, 1998)]
[Rules and Regulations]
[Pages 31612-31613]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-15251]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-45-AD; Amendment 39-10580; AD 98-12-26]
RIN 2120-AA64


Airworthiness Directives; Fokker Model F.28 Mark 1000, 2000, 
3000, and 4000 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Fokker Model F.28 Mark 1000, 2000, 3000, and 4000 
series airplanes, that requires a one-time inspection to determine the 
torque values of the coupling fitting attachment bolts at fuselage 
station 10790, and corrective action, if necessary. This amendment is 
prompted by issuance of mandatory continuing airworthiness information 
by a foreign civil airworthiness authority. The actions specified by 
this AD are intended to prevent loss of the coupling fitting attachment 
bolts between the center wing section and the fuselage, and consequent 
reduced structural integrity of the airplane.

DATES: Effective July 15, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 15, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from Fokker Services B.V., Technical Support Department, P. O. 
Box 75047, 1117 ZN Schiphol Airport, the Netherlands. This information 
may be examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Fokker Model F.28 Mark 
1000, 2000, 3000, and 4000 series airplanes was published in the 
Federal Register on April 6, 1998 (63 FR 16711). That action proposed 
to require a one-time inspection to determine the torque values of the 
coupling fitting attachment bolts at fuselage station 10790, and 
corrective action, if necessary.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 27 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 128 work hours per 
airplane to accomplish the required inspection, and that the average 
labor rate is $60 per work hour. Based on these figures, the cost 
impact of the AD on U.S. operators is estimated to be $207,360, or 
$7,680 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.

[[Page 31613]]

Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-12-26  Fokker Services B.V.: Amendment 39-10580. Docket 98-NM-45-
AD.

    Applicability: Model F.28 Mark 1000, 2000, 3000, and 4000 series 
airplanes; serial numbers 11003 through 11201 inclusive, 11991, and 
11992; on which Fokker Service Bulletin F28/53-125, dated January 
23, 1993, has been accomplished; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of the coupling fitting attachment bolts between 
the center wing section and the fuselage, and consequent reduced 
structural integrity of the airplane, accomplish the following:
    (a) Within 3,000 flight cycles or 1 year after the effective 
date of this AD, whichever occurs later, perform a one-time 
inspection to determine the torque values of the coupling fitting 
attachment bolts between the fuselage and the center wing section at 
fuselage station number 10790, in accordance with Part 1 of the 
Accomplishment Instructions of Fokker Service Bulletin F28/53-143, 
dated August 30, 1996.
    (1) If the torque values are within the limits specified by the 
service bulletin, no further action is required by this AD.
    (2) If the torque value of any bolt is outside the limits 
specified by the service bulletin, prior to further flight, re-
torque the bolt in accordance with the service bulletin.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The actions shall be done in accordance with Fokker Service 
Bulletin F28/53-143, dated August 30, 1996. This incorporation by 
reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Fokker Services B.V., Technical Support Department, 
P.O. Box 75047, 1117 ZN Schiphol Airport, the Netherlands. Copies 
may be inspected at the FAA, Transport Airplane Directorate, 1601 
Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

    Note 3: The subject of this AD is addressed in Dutch 
airworthiness directive 1996-119 (A), dated September 30, 1996.

    (e) This amendment becomes effective on July 15, 1998.

    Issued in Renton, Washington, on June 3, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-15251 Filed 6-9-98; 8:45 am]
BILLING CODE 4910-13-U