AD Amdt-39-10552

final rule

Airworthiness Directives; Dornier Model 328-100 Series Airplanes

AD Number
Amdt-39-10552
Status
final_rule
Effective Date
Product Category
aircraft
Docket
Docket No. 98-NM-46-AD
FR Citation
63 FR 30114

Applicability

TypeManufacturerModelDetails
aircraft Dornier 328-100 Airworthiness Directives; Dornier Model 328-100 Series Airplanes

Unsafe Condition

Failure of the pressure dump and relief valves in the main and auxiliary hydraulic systems could cause a loss in hydraulic pressure for roll control spoilers and brakes, resulting in reduced controllability of the airplane.

AI-generated summary from the source AD text. Verify against the official source before acting.

Required Actions

Replace the existing pressure dump and relief valves in the main and auxiliary hydraulic systems with new valves.

AI-generated summary from the source AD text. Verify against the official source before acting.

Compliance Time

Before further flight

AI-generated summary from the source AD text. Verify against the official source before acting.

Affected Aircraft

Dornier Model 328-100 series airplanes subject to mandatory continuing airworthiness information by a foreign civil airworthiness authority.

AI-generated summary from the source AD text. Verify against the official source before acting.

Federal Register Abstract

This amendment adopts a new airworthiness directive (AD), applicable to certain Dornier Model 328-100 series airplanes, that requires replacement of the existing pressure dump and relief valves in the main and auxiliary hydraulic systems with new valves. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent failure of the pressure dump and relief valves in the main and auxiliary hydraulic systems, which could cause a loss in hydraulic pressure for roll control spoilers and brakes, and consequent reduced controllability of the airplane.

Document Text

Show stored source text (verify against official source)
[Federal Register Volume 63, Number 106 (Wednesday, June 3, 1998)]
[Rules and Regulations]
[Pages 30114-30115]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-14218]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-46-AD; Amendment 39-10552; AD 98-11-27]
RIN 2120-AA64


Airworthiness Directives; Dornier Model 328-100 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain Dornier Model 328-100 series airplanes, that 
requires replacement of the existing pressure dump and relief valves in 
the main and auxiliary hydraulic systems with new valves. This 
amendment is prompted by issuance of mandatory continuing airworthiness 
information by a foreign civil airworthiness authority. The actions 
specified by this AD are intended to prevent failure of the pressure 
dump and relief valves in the main and auxiliary hydraulic systems, 
which could cause a loss in hydraulic pressure for roll control 
spoilers and brakes, and consequent reduced controllability of the 
airplane.

DATES: Effective July 8, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 8, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from FAIRCHILD DORNIER, DORNIER Luftfahrt GmbH, P.O. Box 1103, 
D-82230 Wessling, Germany. This information may be examined at the 
Federal Aviation Administration (FAA), Transport Airplane Directorate, 
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain Dornier Model 328-100 
series airplanes was published in the Federal Register on April 2, 1998 
(63 FR 16167). That action proposed to require replacement of the 
existing pressure dump and relief valves in the main and auxiliary 
hydraulic systems with new valves.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 50 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 6 work hours per 
airplane to accomplish the required replacement, and that the average 
labor rate is $60 per work hour. Required parts will be provided by the 
manufacturer at no cost to the operators. Based on these figures, the 
cost impact of the AD on U.S. operators is estimated to be $18,000, or 
$360 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities

[[Page 30115]]

under the criteria of the Regulatory Flexibility Act. A final 
evaluation has been prepared for this action and it is contained in the 
Rules Docket. A copy of it may be obtained from the Rules Docket at the 
location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.

Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-11-27 Dornier Luftfahrt GmbH: Amendment 39-10552. Docket 98-NM-
46-AD.

    Applicability: Model 328-100 series airplanes, serial numbers 
3005 through 3095 inclusive; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (c) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.
    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the pressure dump and relief valves in the 
main and auxiliary hydraulic systems, which could cause a loss in 
hydraulic pressure for roll control spoilers and brakes, and 
consequent reduced controllability of the airplane, accomplish the 
following:
    (a) Within 8 months after the effective date of this AD, replace 
the existing pressure dump and relief valves having part number (P/
N) ZHV29-1 with new valves having P/N ZHV29-2, in the main and 
auxiliary hydraulic systems, in accordance with Dornier Service 
Bulletin SB-328-29-205, dated February 12, 1997.
    (b) As of the effective date of this AD, no person shall install 
on any airplane any pressure dump and relief valve having P/N ZHV29-
1.
    (c) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (d) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (e) The replacement shall be done in accordance with Dornier 
Service Bulletin SB-328-29-205, dated February 12, 1997. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from FAIRCHILD Dornier, Dornier Luftfahrt 
GmbH, P.O. Box 1103, D-82230 Wessling, Germany. Copies may be 
inspected at the FAA, Transport Airplane Directorate, 1601 Lind 
Avenue, SW., Renton, Washington; or at the Office of the Federal 
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in German 
airworthiness directive 97-072, dated March 27, 1997.

    (f) This amendment becomes effective on July 8, 1998.

    Issued in Renton, Washington, on May 22, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-14218 Filed 6-2-98; 8:45 am]
BILLING CODE 4910-13-U

Source: Official FAA Source ↗

Retrieved: Apr 6, 2026

Rights: U.S. Government Public Domain

This site is not affiliated with or endorsed by the FAA. Always verify with official sources.