AD Amdt-39-10484

[Federal Register Volume 63, Number 79 (Friday, April 24, 1998)]
[Rules and Regulations]
[Pages 20300-20302]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 98-10479]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-226-AD; Amendment 39-10484; AD 98-09-05]
RIN 2120-AA64


Airworthiness Directives; British Aerospace BAe Model ATP 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain British Aerospace BAe Model ATP airplanes, that 
requires repetitive inspections to detect corrosion of the brake 
hydraulic accumulators in the vicinity of the mounting straps; and 
corrective actions, if necessary. This amendment is prompted by 
issuance of mandatory continuing airworthiness information by a foreign 
civil airworthiness authority. The actions specified by this AD are 
intended to detect and correct corrosion of the brake hydraulic 
accumulators, which could lead to loss of hydraulic pressure and 
consequent loss of braking capability of the airplane.

DATES: Effective May 29, 1998.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of May 29, 1998.

ADDRESSES: The service information referenced in this AD may be 
obtained from AI(R) American Support, Inc., 13850 Mclearen Road, 
Herndon, Virginia 20171. This information may be

[[Page 20301]]

examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain British Aerospace BAe 
Model ATP airplanes was published in the Federal Register on February 
10, 1998 (63 FR 6682). That action proposed to require repetitive 
inspections to detect corrosion of the brake hydraulic accumulators in 
the vicinity of the mounting straps; and corrective actions, if 
necessary.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.

Conclusion

    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 10 British Aerospace BAe Model ATP airplanes 
of U.S. registry will be affected by this AD, that it will take 
approximately 2 work hours per airplane to accomplish the required 
inspection, and that the average labor rate is $60 per work hour. Based 
on these figures, the cost impact of the AD on U.S. operators is 
estimated to be $1,200, or $120 per airplane, per inspection cycle.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this final 
rule does not have sufficient federalism implications to warrant the 
preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

98-09-05  British Aerospace Regional Aircraft [Formerly Jetstream 
Aircraft Limited, British Aerospace (Commercial Aircraft) Limited]: 
Amendment 39-10484. Docket 97-NM-226-AD.

    Applicability: BAe Model ATP airplanes, constructor's numbers 
2002 through 2063 inclusive, equipped with brake hydraulic 
accumulators having APPH part number AIR 87342; certificated in any 
category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To detect and correct corrosion of the brake hydraulic 
accumulators, which could lead to loss of hydraulic pressure and 
consequent loss of braking capability of the airplane, accomplish 
the following:
    (a) Within 6 months after the effective date of this AD, perform 
an inspection of the brake hydraulic accumulators for corrosion, in 
accordance with British Aerospace Service Bulletin ATP-32-80, 
Revision 1, dated July 9, 1997. If any discrepancy is found, prior 
to further flight, accomplish corrective actions, as applicable, in 
accordance with the service bulletin. Repeat the inspection 
thereafter at intervals not to exceed 2 years.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.
    (d) The actions shall be done in accordance with British 
Aerospace Service Bulletin ATP-32-80, Revision 1, dated July 9, 
1997, which contains the following list of effective pages:

------------------------------------------------------------------------
                                   Revision level                       
            Page No.               shown on page     Date shown on page 
------------------------------------------------------------------------
1, 3...........................  1................  July 9, 1997.       
2, 4-7.........................  Original.........  June 19, 1997.      
------------------------------------------------------------------------

This incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from AI(R) American Support, Inc., 13850 
Mclearen Road, Herndon, Virginia 20171. Copies may be inspected at 
the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., 
Renton, Washington; or at the Office of the Federal Register, 800 
North Capitol Street, NW., suite 700, Washington, DC.

    Note 3: The subject of this AD is addressed in British 
airworthiness directive 004-06-97 (undated).

    (e) This amendment becomes effective on May 29, 1998.


[[Page 20302]]


    Issued in Renton, Washington, on April 15, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-10479 Filed 4-23-98; 8:45 am]
BILLING CODE 4910-13-P