AD 98-05-12

AD Final Rules - DRS_98-05-12.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
98-05-12
Document Type:
AD Final Rules
Docket Number:
97-NM-191-AD
Subject Heading:
Airworthiness Directives; British Aerospace Model ATP Airplanes
Subject:
AFM - Limitations Section - Roll-Over Lever
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
04/08/1998
Make:
BAE Systems (Operations) Limited
Model:
ATP
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39 [63 FR 10527 NO. 42 03/04/98]
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 98-05-12
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   97-NM-191-AD

AMENDMENT:   39-10373

AD NUMBER:   98-05-12

SUBJECT HEADING:   Airworthiness Directives; British Aerospace Model ATP Airplanes

ACTION:   Final rule

SUMMARY:   This amendment adopts a new airworthiness directive (AD), applicable to all British Aerospace Model ATP airplanes, that requires revising the Airplane Flight Manual (AFM) to modify the limitation that prohibits positioning the power levers below the flight idle stop during flight, and to provide a statement of the consequences of positioning the power levers below the flight idle stop during flight. This amendment is prompted by incidents and accidents involving airplanes equipped with turboprop engines in which the ground propeller beta range was used improperly during flight. The actions specified by this AD are intended to prevent loss of airplane controllability, or engine overspeed and consequent loss of engine power caused by the power levers being positioned below the flight idle stop while the airplane is in flight.

DATES:   Effective April 8, 1998.

ADDRESSES:   Information pertaining to this rulemaking action may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington.

FOR FURTHER INFORMATION CONTACT:   Mark Quam, Aerospace Engineer, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2145; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:  
A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to all British Aerospace Model ATP airplanes was published in the Federal Register on December 31, 1997 (62 FR 68236). That action proposed to require revising the Airplane Flight Manual (AFM) to modify the limitation that prohibits positioning the power levers below the flight idle stop during flight, and to provide a statement of the consequences of positioning the power levers below the flight idle stop during flight.

Comments
Interested persons have been afforded an opportunity to participate in the making of this amendment. Due consideration has been given to the single comment received.

The commenter supports the proposed rule.

Conclusion
After careful review of the available data, including the comment noted above, the FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Interim Action
This is considered interim action until final action is identified, at which time the FAA may consider further rulemaking.

Cost Impact
The FAA estimates that 10 British Aerospace Model ATP airplanes of U.S. registry will be affected by this AD, that it will take approximately 1 work hour per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $600, or $60 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.

Regulatory Impact
The regulations adopted herein will not have substantial direct effects on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, in accordance with Executive Order 12612, it is determined that this final rule does not have sufficient federalism implications to warrant the preparation of a Federalism Assessment.

For the reasons discussed above, I certify that this action (1) is not a "significant regulatory action" under Executive Order 12866; (2) is not a "significant rule" under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption "ADDRESSES."

List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.

Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39 - AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.

§39.13 [Amended]
2. Section 39.13 is amended by adding the following new airworthiness directive:

REGULATORY TEXT:  
98-05-12 BRITISH AEROSPACE REGIONAL AIRCRAFT [Formerly Jetstream Aircraft Limited; British Aerospace (Commercial Aircraft) Limited]: Amendment 39-10373. Docket 97-NM-191-AD.
Applicability: All Model ATP airplanes, certificated in any category.

NOTE 1: This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent loss of airplane controllability, or engine overspeed and consequent loss of engine power caused by the power levers being positioned below the flight idle stop while the airplane is in flight, accomplish the following:

(a) Within 30 days after the effective date of this AD, revise the Limitations Section of the FAA-approved Airplane Flight Manual (AFM) to include the following statements. This action may be accomplished by inserting a copy of this AD into the AFM.

"Roll-over Lever
Use is restricted to ground operation only. In-flight operations at power settings below flight idle are prohibited. Power settings below flight idle may lead to a loss of aircraft control, or may result in an engine overspeed condition and consequent loss of engine power."

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Standardization Branch, ANM-113, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Standardization Branch, ANM-113.

NOTE 2: Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Standardization Branch, ANM-113.

(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

(d) This amendment becomes effective on April 8, 1998.

FOOTER: