AD 90-17-01

AD Final Rules - DRS_90-17-01.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
90-17-01
Document Type:
AD Final Rules
Docket Number:
89-ASW-58
Subject Heading:
Airworthiness Directives; Robinson Helicopter Company (RHC) Model R22 Series Helicopters
Subject:
Carburetor Air Box Latches
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
09/10/1990
Make:
Robinson Helicopter Company
Model:
R22 | R22 ALPHA | R22 BETA | R22 MARINER
Product Type:
Aircraft
Product Subtype:
Rotorcraft
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 90-17-01
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   89-ASW-58

AMENDMENT:   39-6687

AD NUMBER:   90-17-01

SUBJECT HEADING:   Airworthiness Directives; Robinson Helicopter Company (RHC) Model R22 Series Helicopters

ACTION:  

SUMMARY:  

DATES:   Effective on September 10, 1990.

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
90-17-01 ROBINSON HELICOPTER COMPANY (RHC): Amendment 39-6687. Docket No. 89-ASW-58.

Applicability: All Model R22 series helicopters, certified in any category, equipped with carburetor air box latches.

Compliance: Required within the next 25 hours' time in service after the effective date of this AD, unless already accomplished.

To prevent carburetor air box latches from coming loose in flight, which could result in power loss in critical maneuvers close to the ground, accomplish the following:

(a) Remove the three carburetor air box latches and replace with four bolts in accordance with the following:

(1) Open the air box and remove the filter element.

(2) Remove the air box from the helicopter.

(3) Drill out the four rivets in the cover holding 0.25 inch diameter spacers and enlarge the holes to 0.191 inch diameter. Discard the spacers.

(4) Close the cover, and using the holes in the cover as guides, drill four matching holes through the upper box in line with the holes in the cover.

(5) Open the air box and drill out all the rivets holding the latches to the cover. Discard the latches and angles. Clean the drilling chips from the box.

(6) Reinstall the air box to the helicopter.

(7) Install the filter element and secure the cover using four AN3-35A bolts, AN960-10L washers, AN970-3 washers, and NAS679A3 nuts.

NOTE: Refer to Figure 1 for accomplishing the instructions required by paragraph (a).

(b) An alternate method of compliance or adjustment of the compliance time, which provides an equivalent level of safety, may be used if approved by the Manager, Los Angeles Aircraft Certification Office, ANM-100L, FAA, Northwest Mountain Region, 3229 E. Spring Street, Long Beach, California 90806-2425.

NOTE: Robinson Helicopter Company Service Bulletin Number 61, dated July 28, 1989, pertains to this AD.

This amendment (39-6687, AD 90-17-01) becomes effective on September 10, 1990.

SB 61


FOOTER: