AD 86-08-01

AD Final Rules - DRS_86-08-01.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
86-08-01
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
Airworthiness Directives; SHORT BROTHERS, LTD. Model SD3-30 and SD3-60 Series Airplanes
Subject:
Collector Tank Housing
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
04/28/1986
Make:
Short Brothers PLC
Model:
SD3-30 | SD3-60
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 86-08-01
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:   39-5286

AD NUMBER:   86-08-01

SUBJECT HEADING:   Airworthiness Directives; SHORT BROTHERS, LTD. Model SD3-30 and SD3-60 Series Airplanes

ACTION:  

SUMMARY:  

DATES:   Effective April 28, 1986.

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:   86-08-01 SHORT BROTHERS, LTD.: Amendment 39-5286. Applies to Model SD3-30 and SD3-60 series airplanes; serial numbers SH3002 through SH3099, SH3102, and SH3105 (SD3-30 airplanes); SH3601 through SH3661 and SH3663 through SH3665 (SD3-60 airplanes); certificated in any category. Compliance is required as indicated below, unless previously accomplished:

1. Within seven days after the effective date of this AD, inspect the collector tank housing in accordance with Short Brothers Service Bulletin SD330-28-29, dated August 1985 (for SD3-30 series airplanes), and SD360-28-12, Revision 1, dated August 1985 (for SD3-60 series airplanes). If leaks are found, prior to further flight, replace the shrouds and seals in accordance with the applicable service bulletin instructions. If no leaks are found, repeat the inspection at intervals not to exceed 120 hours time in service.

2. Replacement of the existing shrouds and seals in accordance with the applicable service bulletin, referred to in paragraph 1. of this AD, constitutes terminating action for the requirement for the repetitive inspections set forth in paragraph 1., above.

3. An alternate means of compliance or adjustment of the compliance time, which provides an acceptable level of safety, may be used when approved by the Manager, Standardization Branch, ANM-113, FAA, Northwest Mountain Region.

4. Special flight permits may be issued in accordance with FAR 21.197 and 21.199 to operate airplanes to a base for the accomplishment of inspections and/or modifications required by this AD.

All persons affected by this directive who have not already received the appropriate service documents from the manufacturer may obtain copies upon request to Short Brothers, 2011 Crystal Drive, Suite 713, Arlington, Virginia 22202. These documents may be examined at the FAA, Northwest Mountain Region, 17900 Pacific Highway South, Seattle, Washington, or the Seattle Aircraft Certification Office, 9010 East Marginal Way South, Seattle, Washington.

This amendment becomes effective April 28, 1986.

FOOTER: