AD 74-23-04

AD Final Rules - DRS_74-23-04.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
74-23-04
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
Airworthiness Directives; Bellanca Model 8KCAB Aircraft
Subject:
Rib Flanges
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
03/06/1975
Make:
American Champion Aircraft Corp.
Model:
8KCAB
Product Type:
Aircraft
Product Subtype:
Small Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 74-23-04
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:   39-2111

AD NUMBER:   74-23-04

SUBJECT HEADING:   Airworthiness Directives; Bellanca Model 8KCAB Aircraft

ACTION:  

SUMMARY:  

DATES:   Effective March 6, 1975.

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
74-23-04 BELLANCA: Amendment 39-2001 as amended by Amendment 39-2111. Applies to Bellanca Models 8KCAB aircraft S/N's 4-71 thru 159-74.

To detect evidence of fatigue cracks and/or distortion of rib flanges, accomplish the following before further flight:

A. Visually inspect the wing ribs for evidence of fatigue cracks and/or distortion of the rib flanges as follows:

1. Remove fabric from each of four doped-on round reinforcing rings located on lower surface of each wing adjacent to front spar. Use a sharp knife.

2. Using a flashlight (and mirror as necessary) inspect all ribs beginning at first rib outboard of fuel tank and each other rib outboard, to and including last outboard full rib, for general condition.

3. Examine particularly the area approximately 2" aft of front spar (just aft of rib reinforcing gusset) on rib top flange for evidence of cracks, distortion, and fabric holdown rivet looseness.

B. If, as a result of inspection per Paragraph A, cracks, distortion or fabric rivet looseness are found in any of the inspected ribs, repair and reinforce all 30 ribs, 15 ribs per wing, per Bellanca Kit No. 243. Equivalent repairs are to be approved by the Chief, Engineering and Manufacturing Branch, Great Lakes Region, before further flight.

A special flight permit per FAR 21.197 may be issued after accomplishment of Paragraph A to allow repairs in accordance with this Airworthiness Directive.

C. If, as a result of inspection per Paragraph A, no evidence of any cracks, distortion or fabric rivet looseness is found, repeat the required inspection after every 25 hours of flight.

D. The inspection required by Service Letter #113 may be discontinued after installation of Bellanca Kit No. 243.
Amendment 39-2001 was effective November 7, 1974. The telegraphic inspection portion was effective August 20, 1974; for all recipients of the air mail letter of August 20, 1974, which is contained in this amendment.

This amendment 39-2111 becomes effective March 6, 1975.

FOOTER: