AD 55-18-02
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | The Boeing Company | DC-6 | DOUGLAS All Model DC-6 Series Aircraft |
| aircraft | The Boeing Company | DC-6A | DOUGLAS All Model DC-6 Series Aircraft |
| aircraft | The Boeing Company | DC-6B | DOUGLAS All Model DC-6 Series Aircraft |
Unsafe Condition
Inadvertent propeller reversing due to malfunctioning solenoid operated throttle locks and improper throttle operation at touchdown on landing.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Install a protective device requiring a separate and distinct motion to engage reverse pitch range, ensuring safeguards against unlocking when throttles are forward of idle setting. Alternate designs must be FAA-approved if they meet the objectives in paragraph 2.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
As soon as practicable but not later than January 1, 1957.
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
Douglas DC-6, DC-6A, DC-6B aircraft not equipped with the new Douglas Type Propeller Reverse Thrust Mechanical Throttle Lockgate.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
Propeller Reverse Protective Device
Applicability Source Text
Show captured applicability text from the source AD
AD Final Rules - DRS_55-18-02.html Copy URL Print/Save as PDF Document Versions Feedback Details AD Number: 55-18-02 Document Type: AD Final Rules Docket Number: Unknown Subject Heading: DOUGLAS All Model DC-6 Series Aircraft Subject: Propeller Reverse Protective Device Status: Current Citation: This information is not available. Citation Publish Date: Effective Date: Make: The Boeing Company Model: DC-6 | DC-6A | DC-6B Product Type: Aircraft Product Subtype: Large Airplane Affected AD: Superseded AD: Affected By: Superseded By: Service/Office: Office of Primary Responsibility: CFR Part Reference: Part 39 Comments: AIRWORTHINESS DIRECTIVES FINAL RULES: 55-18-02 CITATION: This information is not available. PAGE NUMBER: DOCKET NUMBER: Unknown AMENDMENT: AD NUMBER: 55-18-02 SUBJECT HEADING: DOUGLAS All Model DC-6 Series Aircraft ACTION: SUMMARY: DATES: ADDRESSES: FOR FURTHER INFORMATION CONTACT: SUPPLEMENTARY INFORMATION: REGULATORY TEXT: 55-18-02 DOUGLAS: Applies to All Model DC-6 Series Aircraft That Are Not Equipped With the New Douglas Type Propeller Reverse Thrust Mechanical Throttle Lockgate. Compliance required as soon as practicable but not later than January 1, 1957. 1. Because of instances of inadvertent propeller reversing due to malfunctioning of the solenoid operated throttle locks and improper operation of throttles at time of touchdown on landing, a more positive means of preventing inadvertent movement of the throttles into the reverse segment of the throttle quadrant must be installed. 2. This modification consists of the installation of a protective device which will require a separate and distinct motion by the flight crew member accomplishing the reversing, in order to place the throttles in reverse pitch range. It must also provide safeguards against disarming or unlocking of this protective device when the throttle levers are further forward than idle setting or, if it is possible to unlock at a forward power setting, movement of the throttles toward idle from slow cruise or landing gear warning positions shall reengage the lock prior to reaching the idle position. 3. Douglas Service Bulletin DC-6 No. 557 revised October 15, 1954, covering this modification is an acceptable method of compliance. This bulletin also provides for the continuous operation of the feathering motors during reverse thrust, installs timers to control feathering pump operation during feathering, and deletes the propeller governor pressure cutout switch from the holding circuit. These latter changes, although desirable, are not mandatory. 4. It is possible that some aircraft have already been modified by installation of a protective device which differs in arrangement and detail from the provisions of the Douglas Bulletin. Such alternate designs may be acceptable if the objectives of this directive, as expressed in paragraph 2, have been met. However, because of the many technical considerations involved, all alternate methods of accomplishing this modification should be referred to FAA for engineering evaluation and approval. FOOTER:
Document Text
Show stored source text (verify against official source)
AD Final Rules - DRS_55-18-02.html Copy URL Print/Save as PDF Document Versions Feedback Details AD Number: 55-18-02 Document Type: AD Final Rules Docket Number: Unknown Subject Heading: DOUGLAS All Model DC-6 Series Aircraft Subject: Propeller Reverse Protective Device Status: Current Citation: This information is not available. Citation Publish Date: Effective Date: Make: The Boeing Company Model: DC-6 | DC-6A | DC-6B Product Type: Aircraft Product Subtype: Large Airplane Affected AD: Superseded AD: Affected By: Superseded By: Service/Office: Office of Primary Responsibility: CFR Part Reference: Part 39 Comments: AIRWORTHINESS DIRECTIVES FINAL RULES: 55-18-02 CITATION: This information is not available. PAGE NUMBER: DOCKET NUMBER: Unknown AMENDMENT: AD NUMBER: 55-18-02 SUBJECT HEADING: DOUGLAS All Model DC-6 Series Aircraft ACTION: SUMMARY: DATES: ADDRESSES: FOR FURTHER INFORMATION CONTACT: SUPPLEMENTARY INFORMATION: REGULATORY TEXT: 55-18-02 DOUGLAS: Applies to All Model DC-6 Series Aircraft That Are Not Equipped With the New Douglas Type Propeller Reverse Thrust Mechanical Throttle Lockgate. Compliance required as soon as practicable but not later than January 1, 1957. 1. Because of instances of inadvertent propeller reversing due to malfunctioning of the solenoid operated throttle locks and improper operation of throttles at time of touchdown on landing, a more positive means of preventing inadvertent movement of the throttles into the reverse segment of the throttle quadrant must be installed. 2. This modification consists of the installation of a protective device which will require a separate and distinct motion by the flight crew member accomplishing the reversing, in order to place the throttles in reverse pitch range. It must also provide safeguards against disarming or unlocking of this protective device when the throttle levers are further forward than idle setting or, if it is possible to unlock at a forward power setting, movement of the throttles toward idle from slow cruise or landing gear warning positions shall reengage the lock prior to reaching the idle position. 3. Douglas Service Bulletin DC-6 No. 557 revised October 15, 1954, covering this modification is an acceptable method of compliance. This bulletin also provides for the continuous operation of the feathering motors during reverse thrust, installs timers to control feathering pump operation during feathering, and deletes the propeller governor pressure cutout switch from the holding circuit. These latter changes, although desirable, are not mandatory. 4. It is possible that some aircraft have already been modified by installation of a protective device which differs in arrangement and detail from the provisions of the Douglas Bulletin. Such alternate designs may be acceptable if the objectives of this directive, as expressed in paragraph 2, have been met. However, because of the many technical considerations involved, all alternate methods of accomplishing this modification should be referred to FAA for engineering evaluation and approval. FOOTER:
Source: Official FAA Source ↗
Retrieved: Apr 8, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.