AD 52-08-01

final rule

LOCKHEED Model 18 Aircraft

AD Number
52-08-01
Status
final_rule
Effective Date
Product Category
aircraft
Docket
Unknown
FR Citation
This information is not available.
Technical illustration of an aircraft fuel pump, filter, valve, and lines
Problem area Fuel system

Applicability

TypeManufacturerModelDetails
aircraft Lockheed Aircraft Corporation 18 LOCKHEED Model 18 Aircraft

Unsafe Condition

Failure to seal the inboard end of the integral fuel tanks as per Lockheed Drawing No. 50829, change A, could allow gasoline fumes to accumulate in the passenger compartment in case of fuel tank leakage.

AI-generated summary from the source AD text. Verify against the official source before acting.

Required Actions

Inspect Model 18 Series aircraft converted from military to civil status for compliance with Lockheed Drawing No. 50829, change A. Install diaphragms and vents as required by the drawing. Remove overhead or floor panels to access the area for inspection.

AI-generated summary from the source AD text. Verify against the official source before acting.

Compliance Time

next annual inspection, but in no event later than June 1, 1953

AI-generated summary from the source AD text. Verify against the official source before acting.

Affected Aircraft

Lockheed Aircraft Corporation Model 18 aircraft designated C57, C57B, R50-1, R50-2, R50-3, R50-5, R50-6, C60, C60A, and C59, converted from military versions to civil status

AI-generated summary from the source AD text. Verify against the official source before acting.

Federal Register Abstract

Fuel Tank Seal

Applicability Source Text

Show captured applicability text from the source AD
AD Final Rules - DRS_52-08-01.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
52-08-01
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
LOCKHEED Model 18 Aircraft
Subject:
Fuel Tank Seal
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
Make:
Lockheed Aircraft Corporation
Model:
18
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 52-08-01
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:  

AD NUMBER:   52-08-01

SUBJECT HEADING:   LOCKHEED Model 18 Aircraft

ACTION:  

SUMMARY:  

DATES:  

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
52-08-01 LOCKHEED: Applies to Certificated Army and Navy Versions of the Model 18 Aircraft Designated C57, C57B, R50-1, R50-2, R50-3, R50-5, R50-6, C60, C60A and C59.

Compliance required at next annual inspection, but in no event later than June 1, 1953.

Inspect all Lockheed Model 18 Series aircraft which have been converted from a military version to civil status, for compliance with Lockheed Drawing No. 50829, change A, to provide seal at the inboard end of the integral fuel tanks (inside fuselage) to prevent gasoline fumes from accumulating in the passenger compartment in case of fuel tank leakage. Inspection of the area can be accomplished by removal of the overhead panels adjacent to the fuselage skin in the No. 3 and No. 4 baggage compartments or by removing floor panels in the cabin.

Diaphragms and vents must be installed in accordance with Lockheed Drawing No. 50829 (or equivalent).

(Drawing No. 50829, change A, covering the required installation may be obtained from Lockheed Aircraft Corp., Burbank, Calif.)

FOOTER:

Document Text

Show stored source text (verify against official source)
AD Final Rules - DRS_52-08-01.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
52-08-01
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
LOCKHEED Model 18 Aircraft
Subject:
Fuel Tank Seal
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
Make:
Lockheed Aircraft Corporation
Model:
18
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 52-08-01
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:  

AD NUMBER:   52-08-01

SUBJECT HEADING:   LOCKHEED Model 18 Aircraft

ACTION:  

SUMMARY:  

DATES:  

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
52-08-01 LOCKHEED: Applies to Certificated Army and Navy Versions of the Model 18 Aircraft Designated C57, C57B, R50-1, R50-2, R50-3, R50-5, R50-6, C60, C60A and C59.

Compliance required at next annual inspection, but in no event later than June 1, 1953.

Inspect all Lockheed Model 18 Series aircraft which have been converted from a military version to civil status, for compliance with Lockheed Drawing No. 50829, change A, to provide seal at the inboard end of the integral fuel tanks (inside fuselage) to prevent gasoline fumes from accumulating in the passenger compartment in case of fuel tank leakage. Inspection of the area can be accomplished by removal of the overhead panels adjacent to the fuselage skin in the No. 3 and No. 4 baggage compartments or by removing floor panels in the cabin.

Diaphragms and vents must be installed in accordance with Lockheed Drawing No. 50829 (or equivalent).

(Drawing No. 50829, change A, covering the required installation may be obtained from Lockheed Aircraft Corp., Burbank, Calif.)

FOOTER:

Source: Official FAA Source ↗

Retrieved: Apr 8, 2026

Rights: U.S. Government Public Domain

This site is not affiliated with or endorsed by the FAA. Always verify with official sources.