AD 48-08-01

AD Final Rules - DRS_48-08-01.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
48-08-01
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
Airworthiness Directives; Beech Model 35 Airplanes
Subject:
Starter Rework
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
Make:
Textron Aviation Inc.
Model:
35 | 35-33 | 35-A33 | 35-B33 | 35-C33 | 35-C33A | 35R
Product Type:
Aircraft
Product Subtype:
Small Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 48-08-01
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:  

AD NUMBER:   48-08-01

SUBJECT HEADING:   Airworthiness Directives; Beech Model 35 Airplanes

ACTION:  

SUMMARY:  

DATES:  

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
48-08-01 BEECH: Applies to Model 35 Airplanes Having Serial Numbers Below D-1095 Except D-923, D-925, D-940, D-954, D975, D-983, D-1003, D-1006, D-1013, D-1025, D-1031, D-1038, D-1042, D-1048 Through D-1050, D-1052, D-1053, D-1056 Through D-1062, D-1064, D-1066 Through D-1068, D-1071, D-1072, D-1074, D-1075, D-1077 Through D-1081, D-1083, and D-1085 Through D-1093.

Compliance required by November 1, 1948.

To preclude possible engine malfunctioning as a result of starter gear chipping caused by improper engagement of the starter mechanism, accomplish the following:

(1) Remove the starter assembly from the engine and replace the original starter pinion and clutch assembly with the new assembly, P/N DR1885537. Check the solenoid linkage adjustment to ascertain that the pinion and clutch assembly can move rearward to contact the starter adapter. If the linkage prevents full disengagement of the pinion, remove the toggle link pin and turn the plunger shaft outward until full retraction is obtained. Check to make sure that at least two threads are still engaged. Reinstall the starter assembly.

(2) Install the new resistor coil, P/N DR 1885541, on the starter battery and ground power terminals. The coil must hang downward from the terminals.

(3) Make all electrical connections as covered in Beech Starter Latching Relay Installation Instructions.

(Continental Service Bulletin No. M47-19 dated August 31, 1947, and Beech Service Letter No. 10, Model 35, cover this same subject.)

FOOTER: