AD 47-49-10

final rule

LOCKHEED Model 49 Airplanes

AD Number
47-49-10
Status
final_rule
Effective Date
Product Category
aircraft
Docket
Unknown
FR Citation
This information is not available.

Applicability

TypeManufacturerModelDetails
aircraft Lockheed Aircraft Corporation 49-46 LOCKHEED Model 49 Airplanes

Unsafe Condition

Loss of the astrodome during pressurized cabin operations could result in structural failure or crew injury due to the absence of a cover plate, safety harness, and proper placarding.

AI-generated summary from the source AD text. Verify against the official source before acting.

Required Actions

Install an internal cover plate of 3/16-inch 24ST aluminum alloy or equivalent, provide a navigator's safety harness with floor attachments, placard near the astrodome with specified warning, and inspect astrodome for cracks/crazing before each flight. If new laminated astrodome assembly and ring are installed, some requirements are waived but preflight inspection remains mandatory.

AI-generated summary from the source AD text. Verify against the official source before acting.

Compliance Time

Prior to next flight

AI-generated summary from the source AD text. Verify against the official source before acting.

Affected Aircraft

Lockheed Aircraft Corporation Model 49 airplanes equipped with astrodomes during pressurized cabin operations unless permanently sealed off.

AI-generated summary from the source AD text. Verify against the official source before acting.

Federal Register Abstract

Astrodome Rework

Applicability Source Text

Show captured applicability text from the source AD
AD Final Rules - DRS_47-49-10.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
47-49-10
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
LOCKHEED Model 49 Airplanes
Subject:
Astrodome Rework
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
Make:
Lockheed Aircraft Corporation
Model:
49-46
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 47-49-10
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:  

AD NUMBER:   47-49-10

SUBJECT HEADING:   LOCKHEED Model 49 Airplanes

ACTION:  

SUMMARY:  

DATES:  

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
47-49-10 LOCKHEED: (Was Service Note 10 of AD-763-3.) Applies to All Model 49 Airplanes Which Are Equipped With Astrodomes During Pressurized Cabin Operations, Unless Permanently Sealed Off.

(a) Prior to next flight, provide an internal cover plate for the astrodome opening fabricated of 3/16-inch 24ST aluminum alloy or equivalent, with provisions for installing this plate in the astrodome opening in the event of loss of the astrodome.

(LAC Service Bulletin 49/SB-331 covers this same subject.)

(b) Prior to the next flight, provide a navigator's safety harness with suitable attachments to the floor structure beneath the astrodome.

(LAC Service Bulletin 49/SB-264 covers this same subject.)

(c) Prior to next flight, install a placard adjacent to the astrodome opening, reading as follows: "Wear safety harness whenever using astrodome. Check security of harness attachment to floor after each installation".

(d) Prior to each flight, closely inspect each astrodome for cracks, crazing or other defects, with particular attention given to area around radius adjacent to the flange. When any defects are found, the dome should be replaced at least before the next departure from a terminal base.

(LAC Service Information Letter No. 101 covers the necessary inspection procedure.)

(e) If new type laminated astrodome assembly and ring, LAC Parts 298679 and 298735, respectively, are installed with necessary seals and attachments, the requirements of parts (a), (b), and (c), may be disregarded. The preflight inspection called for in (d) should be continued.

(LAC Service Bulletin 49/SB-324, revised April 30, 1947, covers installation of the new type astrodome and mounting ring.)

FOOTER:

Document Text

Show stored source text (verify against official source)
AD Final Rules - DRS_47-49-10.html
Copy URL
Print/Save as PDF
Document Versions
 Feedback
Details
AD Number:
47-49-10
Document Type:
AD Final Rules
Docket Number:
Unknown
Subject Heading:
LOCKHEED Model 49 Airplanes
Subject:
Astrodome Rework
Status:
Current
Citation:
This information is not available.
Citation Publish Date:
Effective Date:
Make:
Lockheed Aircraft Corporation
Model:
49-46
Product Type:
Aircraft
Product Subtype:
Large Airplane
Affected AD:
Superseded AD:
Affected By:
Superseded By:
Service/Office:
Office of Primary Responsibility:
CFR Part Reference:
Part 39
Comments:
AIRWORTHINESS DIRECTIVES FINAL RULES: 47-49-10
CITATION:   This information is not available.

PAGE NUMBER:  

DOCKET NUMBER:   Unknown

AMENDMENT:  

AD NUMBER:   47-49-10

SUBJECT HEADING:   LOCKHEED Model 49 Airplanes

ACTION:  

SUMMARY:  

DATES:  

ADDRESSES:  

FOR FURTHER INFORMATION CONTACT:  

SUPPLEMENTARY INFORMATION:  

REGULATORY TEXT:  
47-49-10 LOCKHEED: (Was Service Note 10 of AD-763-3.) Applies to All Model 49 Airplanes Which Are Equipped With Astrodomes During Pressurized Cabin Operations, Unless Permanently Sealed Off.

(a) Prior to next flight, provide an internal cover plate for the astrodome opening fabricated of 3/16-inch 24ST aluminum alloy or equivalent, with provisions for installing this plate in the astrodome opening in the event of loss of the astrodome.

(LAC Service Bulletin 49/SB-331 covers this same subject.)

(b) Prior to the next flight, provide a navigator's safety harness with suitable attachments to the floor structure beneath the astrodome.

(LAC Service Bulletin 49/SB-264 covers this same subject.)

(c) Prior to next flight, install a placard adjacent to the astrodome opening, reading as follows: "Wear safety harness whenever using astrodome. Check security of harness attachment to floor after each installation".

(d) Prior to each flight, closely inspect each astrodome for cracks, crazing or other defects, with particular attention given to area around radius adjacent to the flange. When any defects are found, the dome should be replaced at least before the next departure from a terminal base.

(LAC Service Information Letter No. 101 covers the necessary inspection procedure.)

(e) If new type laminated astrodome assembly and ring, LAC Parts 298679 and 298735, respectively, are installed with necessary seals and attachments, the requirements of parts (a), (b), and (c), may be disregarded. The preflight inspection called for in (d) should be continued.

(LAC Service Bulletin 49/SB-324, revised April 30, 1947, covers installation of the new type astrodome and mounting ring.)

FOOTER:

Source: Official FAA Source ↗

Retrieved: Apr 8, 2026

Rights: U.S. Government Public Domain

This site is not affiliated with or endorsed by the FAA. Always verify with official sources.