AD 2017-25-14

[Federal Register Volume 82, Number 239 (Thursday, December 14, 2017)]
[Rules and Regulations]
[Pages 58707-58709]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 2017-26833]


=======================================================================
-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. FAA-2017-1103; Product Identifier 2014-NM-063-AD; Amendment 
39-19128; AD 2017-25-14]
RIN 2120-AA64


Airworthiness Directives; Fokker Services B.V. Airplanes

AGENCY: Federal Aviation Administration (FAA), DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: We are adopting a new airworthiness directive (AD) for Fokker 
Services B.V. Model F28 Mark 0070 and 0100 airplanes. This AD requires 
contacting the FAA to obtain instructions for addressing the unsafe 
condition on these products, and doing the actions specified in those 
instructions. This AD was prompted by a report of an engine multiple 
fan blade-off (MFBO) event, caused by engine fan flutter. We are 
issuing this AD to address the unsafe condition on these products.

DATES: This AD becomes effective December 29, 2017.
    We must receive comments on this AD by January 29, 2018.

ADDRESSES: You may send comments, using the procedures found in 14 CFR 
11.43 and 11.45, by any of the following methods:
    <bullet> Federal eRulemaking Portal: Go to <a href="http://www.regulations.gov">http://www.regulations.gov</a>. Follow the instructions for submitting comments.
    <bullet> Fax: 202-493-2251.
    <bullet> Mail: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE, Washington, DC 20590.
    <bullet> Hand Delivery: U.S. Department of Transportation, Docket 
Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New 
Jersey Avenue SE, Washington, DC, between 9 a.m. and 5 p.m., Monday 
through Friday, except Federal holidays.

Examining the AD Docket

    You may examine the AD docket on the internet at <a href="http://www.regulations.gov">http://www.regulations.gov</a> by searching for and locating Docket No. FAA-2017-
1103; or in person at the Docket Operations office between 9 a.m. and 5 
p.m., Monday through Friday, except Federal holidays. The AD docket 
contains this AD, the regulatory evaluation, any comments received, and 
other information. The street address for the Docket Operations office 
(telephone: 800-647-5527) is in the ADDRESSES section. Comments will be 
available in the AD docket shortly after receipt.

FOR FURTHER INFORMATION CONTACT: Tom Rodriguez, Aerospace Engineer, 
International Section, Transport Standards Branch, FAA, 1601 Lind 
Avenue SW, Renton, WA 98057-3356; telephone: 425-227-1137; fax: 425-
227-1149.

SUPPLEMENTARY INFORMATION: 

Discussion

    The European Aviation Safety Agency (EASA), which is the Technical 
Agent for the Member States of the European Union, has issued EASA AD 
2014-0055, dated March 7, 2014 (referred to after this as the Mandatory 
Continuing Airworthiness Information, or ``the MCAI''), to correct an 
unsafe condition for Fokker Services B.V. Model F28 Mark 0070 and 0100 
airplanes. The MCAI states:

    In 2008, EASA issued AD 2008-0088 to require installation of a 
modified normal maximum (second) detent reverse thrust on F28 Mark 
0100 aeroplanes equipped with TAY 620 engines, except those already 
modified in accordance with Fokker Services Service Bulletin (SB) 
SBF100-76-016.
    Since that [EASA] AD was issued, the investigation into a TAY 
620 Multiple Fan Blade-Off (MFBO) event in September 2012 determined 
that fan flutter was the root cause. It was also determined that, 
under certain conditions, fan flutter can develop on TAY 620 engines 
when the N1 engine speed stabilizes within the range of 54 to 72% 
for more than 7.5 seconds during reverse thrust operation.
    This condition, if not corrected, may lead to further MFBO 
events, possibly resulting in damage to the aeroplane.
    To address this potential unsafe condition, Fokker Services 
published SBF100-76-022 which provides instructions for removing the 
normal maximum (second) detent reverse thrust position and for 
changing the Airplane Flight Manual (AFM) of the affected 
aeroplanes.
    For the reasons described above, this [EASA] AD supersedes EASA 
AD 2008-0088 and requires removal of the normal maximum (second) 
detent reverse thrust position and introduction of changes to the 
AFM.


[[Page 58708]]


    You may examine the MCAI on the internet at <a href="http://www.regulations.gov">http://www.regulations.gov</a> by searching for and locating Docket No. FAA-2017-
1103.

FAA's Determination and Requirements of This AD

    This product has been approved by the aviation authority of another 
country, and is approved for operation in the United States. Pursuant 
to our bilateral agreement with the State of Design Authority, we have 
been notified of the unsafe condition described in the MCAI. We are 
issuing this AD because we evaluated all pertinent information and 
determined the unsafe condition exists and is likely to exist or 
develop on other products of the same type design.

FAA's Determination of the Effective Date

    Since there are currently no domestic operators of this product, we 
find good cause that notice and opportunity for prior public comment 
are unnecessary. In addition, for the reason(s) stated above, we find 
that good cause exists for making this amendment effective in less than 
30 days.

Comments Invited

    This AD is a final rule that involves requirements affecting flight 
safety, and we did not precede it by notice and opportunity for public 
comment. We invite you to send any written relevant data, views, or 
arguments about this AD. Send your comments to an address listed under 
the ADDRESSES section. Include ``Docket No. FAA-2017-1103; Product 
Identifier 2014-NM-063-AD'' at the beginning of your comments. We 
specifically invite comments on the overall regulatory, economic, 
environmental, and energy aspects of this AD. We will consider all 
comments received by the closing date and may amend this AD based on 
those comments.
    We will post all comments we receive, without change, to <a href="http://www.regulations.gov">http://www.regulations.gov</a>, including any personal information you provide. We 
will also post a report summarizing each substantive verbal contact we 
receive about this AD.

Costs of Compliance

    Currently, there are no affected U.S.-registered airplanes. This AD 
requires contacting the FAA to obtain instructions for addressing the 
unsafe condition, and doing the actions specified in those 
instructions. Based on the actions specified in the MCAI AD, we are 
providing the following cost estimates for an affected airplane that is 
placed on the U.S. Register in the future:

                                                 Estimated Costs
----------------------------------------------------------------------------------------------------------------
                 Action                          Labor cost           Parts cost          Cost per product
----------------------------------------------------------------------------------------------------------------
Modification, Aircraft Maintenance       Up to 5 work-hours x $85               $0  Up to $425.
 Manual/AFM updates.                      per hour = $425.
----------------------------------------------------------------------------------------------------------------

Authority for This Rulemaking

    Title 49 of the United States Code specifies the FAA's authority to 
issue rules on aviation safety. Subtitle I, section 106, describes the 
authority of the FAA Administrator. ``Subtitle VII: Aviation 
Programs,'' describes in more detail the scope of the Agency's 
authority.
    We are issuing this rulemaking under the authority described in 
``Subtitle VII, Part A, Subpart III, Section 44701: General 
requirements.'' Under that section, Congress charges the FAA with 
promoting safe flight of civil aircraft in air commerce by prescribing 
regulations for practices, methods, and procedures the Administrator 
finds necessary for safety in air commerce. This regulation is within 
the scope of that authority because it addresses an unsafe condition 
that is likely to exist or develop on products identified in this 
rulemaking action.
    This AD is issued in accordance with authority delegated by the 
Executive Director, Aircraft Certification Service, as authorized by 
FAA Order 8000.51C. In accordance with that order, issuance of ADs is 
normally a function of the Compliance and Airworthiness Division, but 
during this transition period, the Executive Director has delegated the 
authority to issue ADs applicable to transport category airplanes to 
the Director of the System Oversight Division.

Regulatory Findings

    We determined that this AD will not have federalism implications 
under Executive Order 13132. This AD will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government.
    For the reasons discussed above, I certify that this AD:
    1. Is not a ``significant regulatory action'' under Executive Order 
12866;
    2. Is not a ``significant rule'' under the DOT Regulatory Policies 
and Procedures (44 FR 11034, February 26, 1979);
    3. Will not affect intrastate aviation in Alaska; and
    4. Will not have a significant economic impact, positive or 
negative, on a substantial number of small entities under the criteria 
of the Regulatory Flexibility Act.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, under the authority delegated to me by the 
Administrator, the FAA amends 14 CFR part 39 as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. The FAA amends Sec.  39.13 by adding the following new airworthiness 
directive (AD):

2017-25-14 Fokker Services B.V.: Amendment 39-19128; Docket No. FAA-
2017-1103; Product Identifier 2014-NM-063-AD.

(a) Effective Date

    This AD becomes effective December 29, 2017.

(b) Affected ADs

    None.

(c) Applicability

    This AD applies to the Fokker Services B.V. airplanes, 
certificated in any category, identified in paragraphs (c)(1) and 
(c)(2) of this AD.
    (1) Model F28 Mark 0070 airplanes, all serial numbers.

[[Page 58709]]

    (2) Model F28 Mark 0100 airplanes equipped with Rolls-Royce 
Deutschland TAY-620-15 engines.

(d) Subject

    Air Transport Association (ATA) of America Code 76, Engine 
controls.

(e) Reason

    This AD was prompted by a report of an engine multiple fan 
blade-off (MFBO) event, caused by engine fan flutter. We are issuing 
this AD to prevent engine MFBO events, which could lead to 
structural damage and possible reduced controllability of the 
airplane.

(f) Compliance

    Comply with this AD within the compliance times specified, 
unless already done.

(g) Required Action(s)

    Within 30 days after the effective date of this AD, request 
instructions from the Manager, International Section, Transport 
Standards Branch, FAA, to address the unsafe condition specified in 
paragraph (e) of this AD; and accomplish the action(s) at the times 
specified in, and in accordance with, those instructions. Guidance 
can be found in Mandatory Continuing Airworthiness Information 
(MCAI) European Aviation Safety Agency (EASA) AD 2014-0055, dated 
March 7, 2014.

(h) Alternative Methods of Compliance (AMOCs)

    The Manager, International Section, Transport Standards Branch, 
FAA, has the authority to approve AMOCs for this AD, if requested 
using the procedures found in 14 CFR 39.19. In accordance with 14 
CFR 39.19, send your request to your principal inspector or local 
Flight Standards District Office, as appropriate. If sending 
information directly to the International Section, send it to the 
attention of the person identified in paragraph (i)(2) of this AD. 
Information may be emailed to: <a href="/cdn-cgi/l/email-protection#576e7a16191a7a6666617a161a18147a05120602120403041731363679303821"><span class="__cf_email__" data-cfemail="cff6e28e8182e2fefef9e28e82808ce29d8a9e9a8a9c9b9c8fa9aeaee1a8a0b9">[email&#160;protected]</span></a>. 
Before using any approved AMOC, notify your appropriate principal 
inspector, or lacking a principal inspector, the manager of the 
local flight standards district office/certificate holding district 
office.

(i) Related Information

    (1) Refer to MCAI EASA AD 2014-0055, dated March 7, 2014, for 
related information. You may examine the MCAI on the internet at 
<a href="http://www.regulations.gov">http://www.regulations.gov</a> by searching for and locating Docket No. 
FAA-2017-1103.
    (2) For more information about this AD, contact Tom Rodriguez, 
Aerospace Engineer, International Section, Transport Standards 
Branch, FAA, 1601 Lind Avenue SW, Renton, WA 98057-3356; telephone: 
425-227-1137; fax: 425-227-1149.

(j) Material Incorporated by Reference

    None.

    Issued in Renton, Washington, on December 6, 2017.
Dionne Palermo,
Acting Director, System Oversight Division, Aircraft Certification 
Service.
[FR Doc. 2017-26833 Filed 12-13-17; 8:45 am]
BILLING CODE 4910-13-P