AD 2003-12-02

[Federal Register Volume 68, Number 113 (Thursday, June 12, 2003)]
[Rules and Regulations]
[Pages 35163-35164]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 03-14522]



[[Page 35163]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2002-NM-162-AD; Amendment 39-13187; AD 2003-12-02]
RIN 2120-AA64


Airworthiness Directives; BAE Systems (Operations) Limited Model 
ATP Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all BAE Systems (Operations) Limited Model ATP airplanes, 
that requires installing a baulking device for the pintle pin in the 
nose landing gear (NLG). This action is necessary to prevent failure of 
the NLG due to an unlocked pintle pin migrating from its support 
housings, and consequent jamming or collapse of the NLG. This action is 
intended to address the identified unsafe condition.

DATES: Effective July 17, 2003.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of July 17, 2003.

ADDRESSES: The service information referenced in this AD may be 
obtained from British Aerospace Regional Aircraft American Support, 
13850 Mclearen Road, Herndon, Virginia 20171. This information may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Todd Thompson, Aerospace Engineer, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-1175; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all BAE Systems (Operations) 
Limited Model ATP airplanes was published in the Federal Register on 
March 17, 2003 (68 FR 12614). That action proposed to require 
installing a baulking device for the pintle pin in the nose landing 
gear.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Changes to 14 CFR Part 39/Effect on the AD

    On July 10, 2002, the FAA issued a new version of 14 CFR part 39 
(67 FR 47997, July 22, 2002), which governs the FAA's airworthiness 
directives system. The regulation now includes material that relates to 
altered products, special flight permits, and alternative methods of 
compliance. However, for clarity and consistency in this final rule, we 
have retained the language of the NPRM regarding that material.

Cost Impact

    The FAA estimates that 3 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 20 work hours per 
airplane to accomplish the required installation, and that the average 
labor rate is $60 per work hour. Required parts will cost approximately 
$900 per airplane. Based on these figures, the cost impact of the AD on 
U.S. operators is estimated to be $6,300, or $2,100 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

0
Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

0
1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec.  39.13  [Amended]

0
2. Section 39.13 is amended by adding the following new airworthiness 
directive:

2003-12-02 BAE Systems (Operations) Limited (Formerly British 
Aerospace Regional Aircraft): Amendment 39-13187. Docket 2002-NM-
162-AD.

    Applicability: All Model ATP airplanes, certificated in any 
category.
    Compliance: Required as indicated, unless accomplished 
previously.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the installation, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the nose landing gear (NLG) due to an 
unlocked pintle pin migrating from its support housings, and 
consequent jamming or collapse of the NLG, accomplish the following:

[[Page 35164]]

Installation

    (a) Within 3 years after the effective date of this AD, install 
a baulking device for the pintle pin in the NLG by accomplishing the 
actions specified in the Accomplishment Instructions of BAE Systems 
(Operations) Limited Service Bulletin ATP-32-105, dated April 9, 
2002. The actions must be done per the service bulletin.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, 
Transport Airplane Directorate, FAA. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with BAE Systems 
(Operations) Limited Service Bulletin ATP-32-105, dated April 9, 
2002. This incorporation by reference was approved by the Director 
of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR 
part 51. Copies may be obtained from British Aerospace Regional 
Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 
20171. Copies may be inspected at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

    Note 3: The subject of this AD is addressed in British 
airworthiness directive 004-04-2002.

Effective Date

    (e) This amendment becomes effective on July 17, 2003.

    Issued in Renton, Washington, on June 4, 2003.
Ali Bahrami,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 03-14522 Filed 6-11-03; 8:45 am]
BILLING CODE 4910-13-P