AD 2001-20-19

[Federal Register Volume 66, Number 200 (Tuesday, October 16, 2001)]
[Rules and Regulations]
[Pages 52496-52498]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 01-25662]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2001-NM-131-AD; Amendment 39-12468; AD 2001-20-19]
RIN 2120-AA64


Airworthiness Directives; McDonnell Douglas Model MD-90-30 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule; request for comments.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD) that 
is applicable to certain McDonnell Douglas Model MD-90-30 series 
airplanes. This action requires a visual inspection for heat damage, 
arcing, and loose terminal screws of the ground service electrical 
circuit breaker panel, and corrective actions, if necessary. This 
action is necessary to prevent overheating or arcing of circuit 
breakers in the ground service electrical circuit breaker panel, which 
could result in damage to the circuit breaker, wiring, or surrounding 
insulation blankets, and consequent smoke or fire in the flightdeck. 
This action is intended to address the identified unsafe condition.

DATES: Effective October 31, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of October 31, 2001.
    Comments for inclusion in the Rules Docket must be received on or 
before December 17, 2001.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 2001-NM-131-AD, 1601 Lind Avenue, SW., 
Renton, Washington 98055-4056. Comments may be inspected at this 
location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except 
Federal holidays. Comments may be submitted via fax to (425) 227-1232. 
Comments may also be sent via the Internet using the following address: 
<a href="/cdn-cgi/l/email-protection#84bda9e5eae9a9ede5f6e7ebe9e9e1eaf0c4e2e5e5aae3ebf2"><span class="__cf_email__" data-cfemail="0831256966652561697a6b6765656d667c486e6969266f677e">[email&#160;protected]</span></a>. Comments sent via fax or the Internet must 
contain ``Docket No. 2001-NM-131-AD'' in the subject line and need not 
be submitted in triplicate. Comments sent via the Internet as attached 
electronic files must be formatted in Microsoft Word 97 for Windows or 
ASCII text.
    The service information referenced in this AD may be obtained from 
Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood 
Boulevard, Long Beach, California 90846, Attention: Data and Service 
Management, Dept. C1-L5A (D800-0024). This information may be examined 
at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., 
Renton, Washington; or at the FAA, Los Angeles Aircraft Certification 
Office, 3960 Paramount Boulevard, Lakewood, California; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: George Mabuni, Aerospace Engineer, 
Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft 
Certification Office, 3960 Paramount Boulevard, Lakewood, California 
90712-4137; telephone (562) 627-5341; fax (562) 627-5210.

SUPPLEMENTARY INFORMATION: The FAA has received a report indicating 
that an inspection to determine the cause of a popped circuit breaker 
revealed burn marks and a loose terminal screw at the bus bar side of a 
circuit breaker in the ground service electrical circuit breaker panel 
on a McDonnell Douglas Model MD-90-30 series airplane. Further 
inspection revealed that several more circuit breakers in the same 
circuit breaker panel were also found to have loose terminal screws. 
The loose terminal screws of the circuit breaker were attributed to 
incorrect reinstallation of electrical components after replacement of 
circuit breaker panel, which had misdrilled mounting holes during 
production. This condition, if not corrected, could result in damage to 
the circuit breaker, wiring, or surrounding insulation blankets, and 
consequent smoke or fire in the flightdeck.

Explanation of Relevant Service Information

    The FAA has reviewed and approved McDonnell Alert Service Bulletin 
MD90-24A049, dated September 18, 1997, which describes procedures for a 
visual inspection of the circuit breakers of the ground service 
electrical circuit breaker panel located in the left console, for heat 
damage, arcing, or loose terminal screws. The alert service bulletin 
also describes procedures for replacing any circuit breaker having heat 
damage or evidence of arcing with a new circuit breaker, and tightening 
any loose terminal screw on the circuit breakers. Accomplishment of the 
actions specified in the service bulletin is intended to adequately 
address the identified unsafe condition.

Explanation of Requirements of the Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design that may be 
registered in the United States at some time in the future, this AD is 
being issued to prevent damage to the circuit breaker, wiring, or 
surrounding insulation blankets due to overheating or arcing of the 
circuit breakers, which could result in smoke or fire in the 
flightdeck. This AD requires accomplishment of the actions specified in 
the service bulletin described previously.

Cost Impact

    None of the airplanes affected by this action are on the U.S. 
Register. All airplanes included in the applicability of this rule 
currently are operated by non-U.S. operators under foreign registry; 
therefore, they are not directly affected by this AD action. However, 
the FAA considers that this rule is necessary to ensure that the unsafe 
condition is addressed in the event that any of these subject airplanes 
are imported and placed on the U.S. Register in the future.
    Should an affected airplane be imported and placed on the U.S. 
Register in the future, it would require approximately 1 work hour to 
accomplish the required actions at an average labor rate of $60 per 
work hour. Based on these figures, the cost impact of this AD would be 
$60 per airplane.

Determination of Rule's Effective Date

    Since this AD action does not affect any airplane that is currently 
on the U.S. register, it has no adverse economic

[[Page 52497]]

impact and imposes no additional burden on any person. Therefore, prior 
notice and public procedures hereon are unnecessary and the amendment 
may be made effective in less than 30 days after publication in the 
Federal Register.

Comments Invited

    Although this action is in the form of a final rule and was not 
preceded by notice and opportunity for public comment, comments are 
invited on this rule. Interested persons are invited to comment on this 
rule by submitting such written data, views, or arguments as they may 
desire. Communications shall identify the Rules Docket number and be 
submitted in triplicate to the address specified under the caption 
ADDRESSES. All communications received on or before the closing date 
for comments will be considered, and this rule may be amended in light 
of the comments received. Factual information that supports the 
commenter's ideas and suggestions is extremely helpful in evaluating 
the effectiveness of the AD action and determining whether additional 
rulemaking action would be needed.
    Submit comments using the following format:
    <bullet> Organize comments issue-by-issue. For example, discuss a 
request to change the compliance time and a request to change the 
service bulletin reference as two separate issues.
    <bullet> For each issue, state what specific change to the AD is 
being requested.
    <bullet> Include justification (e.g., reasons or data) for each 
request.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the rule that might 
suggest a need to modify the rule. All comments submitted will be 
available, both before and after the closing date for comments, in the 
Rules Docket for examination by interested persons. A report that 
summarizes each FAA-public contact concerned with the substance of this 
AD will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this rule must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 2001-NM-131-AD.'' The postcard will be date stamped 
and returned to the commenter.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2001-20-19  McDonnell Douglas: Amendment 39-12468. Docket 2001-NM-
131-AD.

    Applicability: Model MD-90-30 series airplanes, as listed in 
McDonnell Douglas Alert Service Bulletin MD90-24A049, dated 
September 18, 1997; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent overheating or arcing of circuit breakers in the 
ground service electrical circuit breaker panel, which could result 
in damage to the circuit breaker, wiring, or surround insulation 
blankets, and consequent smoke or fire in the flightdeck; accomplish 
the following:

Inspection and Corrective Actions, If Necessary

    (a) Within 60 days after the effective date of this AD: Perform 
a general visual inspection of the circuit breakers and electrical 
terminals in the ground service electrical circuit breaker panel for 
heat damage, arcing, and loose terminal screws, per McDonnell 
Douglas Alert Service Bulletin MD90-24A049, dated September 18, 
1997.

    Note 2: For the purposes of this AD, a general visual inspection 
is defined as: ``A visual examination of an interior or exterior 
area, installation, or assembly to detect obvious damage, failure, 
or irregularity. This level of inspection is made under normally 
available lighting conditions such as daylight, hangar lighting, 
flashlight, or drop-light, and may require removal or opening of 
access panels or doors. Stands, ladders, or platforms may be 
required to gain proximity to the area being checked.''

    (1) If no heat damage, arcing, or loose terminal screw is 
detected, no further action is required by this AD.
    (2) If any circuit breaker or terminal has heat damage or 
evidence of arcing is detected, before further flight, replace the 
circuit breaker with a new circuit breaker, per the alert service 
bulletin.
    (3) If any terminal screw of the circuit breaker is loose, 
before further flight, tighten the screw, per the alert service 
bulletin.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO), FAA. Operators shall submit their requests through an 
appropriate FAA Principal Maintenance Inspector, who may add 
comments and then send it to the Manager, Los Angeles ACO.

    Note 3: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with McDonnell 
Douglas Alert Service Bulletin MD90-24A049, dated September 18, 
1997. This incorporation by reference was

[[Page 52498]]

approved by the Director of the Federal Register in accordance with 
5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from 
Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood 
Boulevard, Long Beach, California 90846, Attention: Data and Service 
Management, Dept. C1-L5A (D800-0024). Copies may be inspected at the 
FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington; or at the FAA, Los Angeles Aircraft Certification 
Office, 3960 Paramount Boulevard, Lakewood, California; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

Effective Date

    (e) This amendment becomes effective on October 31, 2001.

    Issued in Renton, Washington, on October 5, 2001.
Vi L. Lipski,
Manager, Transport Airplane Directorate, Aircraft Certification 
Service.

[FR Doc. 01-25662 Filed 10-15-01; 8:45 am]
BILLING CODE 4910-13-P