AD 2001-17-07
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | The Boeing Company | MD-11 | Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes |
| aircraft | The Boeing Company | MD-11F | Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes |
Unsafe Condition
Electrical failures in the cargo control units (CCU) could result in sparks or flame in the CCU container and lead to fire in the insulation blanket or adjacent equipment.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Replace the insulation blankets of the forward and center cargo compartments in the area of the CCU's with new insulation blankets, per Boeing Alert Service Bulletin MD11-25A244, dated August 10, 2000, or Revision 01, dated October 31, 2000. Insulation blankets made from metallized polyethyleneteraphthalate (MPET) may not be used.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
Within 6 months after the effective date of this AD.
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
McDonnell Douglas Model MD-11 series airplanes, as listed in Boeing Alert Service Bulletin MD11-25A244, Revision 01, dated October 31, 2000; certificated in any category.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model MD-11 series airplanes, that requires replacement of the insulation blankets of the forward and center cargo compartments in the area of the cargo control units (CCU) with new insulation blankets. This action is necessary to protect against electrical failures in the CCUs, which could result in sparks or flame in the CCU container and lead to fire in the insulation blanket or adjacent equipment. This action is intended to address the identified unsafe condition.
Document Text
Show stored source text (verify against official source)
[Federal Register Volume 66, Number 163 (Wednesday, August 22, 2001)]
[Rules and Regulations]
[Pages 44044-44046]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 01-20934]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2000-NM-187-AD; Amendment 39-12398; AD 2001-17-07]
RIN 2120-AA64
Airworthiness Directives; McDonnell Douglas Model MD-11 Series
Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain McDonnell Douglas Model MD-11 series airplanes,
that requires replacement of the insulation blankets of the forward and
center cargo compartments in the area of the cargo control units (CCU)
with new insulation blankets. This action is necessary to protect
against electrical failures in the CCUs, which could result in sparks
or flame in the CCU container and lead to fire in the insulation
blanket or adjacent equipment. This action is intended to address the
identified unsafe condition.
DATES: Effective September 26, 2001.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of September 26, 2001.
ADDRESSES: The service information referenced in this AD may be
obtained from Boeing Commercial Aircraft Group, Long Beach Division,
3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data
and Service Management, Dept. C1-L5A (D800-0024). This information may
be examined at the Federal Aviation Administration (FAA), Transport
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton,
Washington; or at the FAA, Los Angeles Aircraft Certification Office,
3960 Paramount Boulevard, Lakewood, California; or at the Office of the
Federal Register, 800 North Capitol Street, NW., suite 700, Washington,
DC.
FOR FURTHER INFORMATION CONTACT: Brett Portwood, Aerospace Engineer,
Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft
Certification Office, 3960 Paramount Boulevard, Lakewood, California
90712-4137; telephone (562) 627-5350; fax (562) 627-5210.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain McDonnell Douglas Model
MD-11 series airplanes was published in the Federal Register on
February 20, 2001 (66 FR 10855). That action proposed to require
replacement of the insulation blankets of the forward and center cargo
compartments in the area of the cargo control units (CCU) with new
insulation blankets.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. Due consideration has been given to
the comments received.
[[Page 44045]]
Address Change for Obtaining Service Information
The airplane manufacturer states that the referenced department
name, number, and mail code of the address for obtaining service
information are incorrect in the proposed AD. The correct address is
Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood
Boulevard, Long Beach, California 90846, Attention: Data and Service
Management, Dept. C1-L5A (D800-0024). The airplane manufacturer
requests that the proposed AD be revised accordingly. The FAA agrees
and has revised this address in the final rule.
Delay Issuance of Final Rule
One commenter requests that the FAA delay issuance of the final
rule until an on aircraft verfication has been performed. The FAA does
not agree. To delay this final rule would be inappropriate, since we
have determined that an unsafe condition exists and that the insulation
blankets must be replaced to ensure continued safety.
Conclusion
After careful review of the available data, including the comments
noted above, the FAA has determined that air safety and the public
interest require the adoption of the rule with the change previously
described. The FAA has determined that this change will neither
increase the economic burden on any operator nor increase the scope of
the AD.
Cost Impact
There are approximately 91 Model MD-11 series airplanes of the
affected design in the worldwide fleet. The FAA estimates that 22
airplanes of U.S. registry will be affected by this AD, that it will
take approximately 3 work hours per airplane to accomplish the required
actions, and that the average labor rate is $60 per work hour. Required
parts will be supplied by the airplane manufacturer at no cost to the
operators. Based on these figures, the cost impact of the AD on U.S.
operators is estimated to be $3,960, or $180 per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted. The cost impact figures discussed
in AD rulemaking actions represent only the time necessary to perform
the specific actions actually required by the AD. These figures
typically do not include incidental costs, such as the time required to
gain access and close up, planning time, or time necessitated by other
administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
``ADDRESSES.''
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
2001-17-07 McDonnell Douglas: Amendment 39-12398. Docket 2000-NM-
187-AD.
Applicability: Model MD-11 series airplanes, as listed in Boeing
Alert Service Bulletin MD11-25A244, Revision 01, dated October 31,
2000; certificated in any category.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (b) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To protect against electrical failures in the cargo control
units (CCU), which could result in sparks or flame in the CCU
container and lead to fire in the insulation blanket or adjacent
equipment, accomplish the following:
Replacement
(a) Within 6 months after the effective date of this AD, replace
the insulation blankets of the forward and center cargo compartments
in the area of the CCU's with new insulation blankets, per Boeing
Alert Service Bulletin MD11-25A244, dated August 10, 2000, or
Revision 01, dated October 31, 2000. Insulation blankets made from
metallized polyethyleneteraphthalate (MPET) may not be used.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Los Angeles Aircraft Certification
Office (ACO), FAA. Operators shall submit their requests through an
appropriate FAA Principal Maintenance Inspector, who may add
comments and then send it to the Manager, Los Angeles ACO.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Los Angeles ACO.
Special Flight Permits
(c) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Incorporation by Reference
(d) The actions shall be done in accordance with Boeing Alert
Service Bulletin MD11-25A244, dated August 10, 2000; or Boeing Alert
Service Bulletin MD11-25A244, Revision 01, dated October 31, 2000.
This incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from Boeing Commercial Aircraft Group,
Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California
90846, Attention: Data and Service Management, Dept. C1-L5A (D800-
0024). Copies may be inspected at the FAA, Transport Airplane
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the
[[Page 44046]]
FAA, Los Angeles Aircraft Certification Office, 3960 Paramount
Boulevard, Lakewood, California; or at the Office of the Federal
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Effective Date
(e) This amendment becomes effective on September 26, 2001.
Issued in Renton, Washington, on August 14, 2001.
Vi L. Lipski,
Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 01-20934 Filed 8-21-01; 8:45 am]
BILLING CODE 4910-13-P
Source: Official FAA Source ↗
Retrieved: Apr 6, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.