AD 2001-13-08
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | 328 Support Services GmbH | 328-300 | Airworthiness Directives; Dornier Model 328-300 Series Airplanes |
Unsafe Condition
Overheating of the brakes, which could result in cracked pistons and consequent leakage and burning of the hydraulic fluid.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Replace the left and right brake assemblies having part number AHA2227-2 with modified brake assemblies having part number AHA2227-3, in accordance with Dornier Service Bulletin SB-328J-32-029, Revision 1, dated August 4, 2000. No person may install a brake assembly having part number AHA2227-2 on any airplane as of the effective date of this AD.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
Within 7 weeks after the effective date of this AD.
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
Dornier Model 328-300 series airplanes, certificated in any category, serial numbers 3105 through 3144 inclusive, 3146, 3148, 3151 through 3154 inclusive, 3158, and 3159.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
This amendment adopts a new airworthiness directive (AD), applicable to certain Dornier Model 328-300 series airplanes, that requires replacing the brake assemblies with modified brake assemblies. The actions specified by this AD are intended to prevent overheating of the brakes, which could result in cracked pistons and consequent leakage and burning of the hydraulic fluid. This action is intended to address the identified unsafe condition.
Document Text
Show stored source text (verify against official source)
[Federal Register Volume 66, Number 124 (Wednesday, June 27, 2001)]
[Rules and Regulations]
[Pages 34090-34091]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 01-15935]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 2000-NM-339-AD; Amendment 39-12288; AD 2001-13-08]
RIN 2120-AA64
Airworthiness Directives; Dornier Model 328-300 Series Airplanes
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment adopts a new airworthiness directive (AD),
applicable to certain Dornier Model 328-300 series airplanes, that
requires replacing the brake assemblies with modified brake assemblies.
The actions specified by this AD are intended to prevent overheating of
the brakes, which could result in cracked pistons and consequent
leakage and burning of the hydraulic fluid. This action is intended to
address the identified unsafe condition.
DATES: Effective August 1, 2001.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of August 1, 2001.
ADDRESSES: The service information referenced in this AD may be
obtained from Fairchild Dornier, Dornier Luftfahrt GmbH, P.O. Box 1103,
D-82230 Wessling, Germany. This information may be examined at these
Federal Aviation Administration (FAA), Transport Airplane Directorate,
Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the
Office of the Federal Register, 800 North Capitol Street, NW., suite
700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Dan Rodina, Aerospace Engineer,
International Branch, ANM-116, FAA, Transport Airplane Directorate,
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425)
227-2125; fax (425) 227-1149.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) to include an airworthiness
directive (AD) that is applicable to certain Dornier Model 328-300
series airplanes was published in the Federal Register on May 4, 2001
(66 FR 22484). That action proposed to require replacing the brake
assemblies with modified brake assemblies.
Comments
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were submitted in response
to the proposal or the FAA's determination of the cost to the public.
Conclusion
The FAA has determined that air safety and the public interest
require the adoption of the rule as proposed.
Cost Impact
The FAA estimates that 8 airplanes of U.S. registry will be
affected by this AD, that it will take approximately 9 work hours per
airplane to accomplish the required actions, and that the average labor
rate is $60 per work hour. Required parts will be provided at the
manufacturer at no cost to operators. Based on these figures, the cost
impact of the AD on U.S. operators is estimated to be $4,320, or $540
per airplane.
The cost impact figure discussed above is based on assumptions that
no operator has yet accomplished any of the requirements of this AD
action, and that no operator would accomplish those actions in the
future if this AD were not adopted. The cost impact figures discussed
in AD rulemaking actions represent only the time necessary to perform
the specific actions actually required by the AD. These figures
typically do not include incidental costs, such as the time required to
gain access and close up, planning time, or time necessitated by other
administrative actions.
Regulatory Impact
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding the following new
airworthiness directive:
2001-13-08 Dornier Luftfahrt GmbH: Amendment 39-12288. Docket 2000-
NM-339-AD.
Applicability: Model 328-300 series airplanes, certificated in
any category, serial numbers 3105 through 3144 inclusive, 3146,
3148, 3151 through 3154 inclusive, 3158, and 3159.
Note 1: This AD applies to each airplane identified in the
preceding applicability provision, regardless of whether it has been
modified, altered, or repaired in the area subject to the
requirements of this AD. For airplanes that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the
[[Page 34091]]
owner/operator must request approval for an alternative method of
compliance in accordance with paragraph (c) of this AD. The request
should include an assessment of the effect of the modification,
alteration, or repair on the unsafe condition addressed by this AD;
and, if the unsafe condition has not been eliminated, the request
should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent overheating of the brakes, which could result in
cracked pistons and consequent leakage and burning of the hydraulic
fluid, accomplish the following:
Brake Piston Replacement
(a) Within 7 weeks after the effective date of this AD, replace
the left and right brake assemblies having part number (P/N)
AHA2227-2 with modified brake assemblies having P/N AHA2227-3, in
accordance with Dornier Service Bulletin SB-328J-32-029, Revision 1,
dated August 4, 2000.
Note 2: Replacement of the brake assemblies prior to the
effective date of this AD in accordance with Dornier Service
Bulletin SB-328J-32-029, dated June 14, 2000, is also acceptable for
compliance with the requirements of paragraph (a) of this AD.
Spares
(b) As of the effective date of this AD, no person may install a
brake assembly having P/N AHA2227-2 on any airplane.
Alternative Methods of Compliance
(c) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, International Branch, ANM-116,
Transport Airplane Directorate, FAA. Operators shall submit their
requests through an appropriate FAA Principal Maintenance Inspector,
who may add comments and then send it to the Manager, International
Branch, ANM-116.
Note 3: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the International Branch, ANM-116.
Special Flight Permits
(d) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the airplane to a location where
the requirements of this AD can be accomplished.
Incorporation by Reference
(e) The actions shall be done in accordance with Dornier Service
Bulletin SB-328J-32-029, Revision 1, dated August 4, 2000. This
incorporation by reference was approved by the Director of the
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part
51. Copies may be obtained from FAIRCHILD DORNIER, DORNIER Luftfahrt
GmbH, P.O. Box 1103, D-82230 Wessling, Germany. Copies may be
inspected at the FAA, Transport Airplane Directorate, 1601 Lind
Avenue, SW., Renton, Washington; or at the Office of the Federal
Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
Note 4: The subject of this AD is addressed in German
airworthiness directive 2000-288, dated September 21, 2000.
Effective Date
(f) This amendment becomes effective on August 1, 2001.
Issued in Renton, Washington, on June 19, 2001.
Kalene C. Yanamura,
Acting Manager, Transport Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 01-15935 Filed 6-26-01; 8:45 am]
BILLING CODE 4910-13-P
Source: Official FAA Source ↗
Retrieved: Apr 6, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.