AD 2001-01-12

[Federal Register Volume 66, Number 16 (Wednesday, January 24, 2001)]
[Rules and Regulations]
[Pages 7575-7576]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 01-1661]



[[Page 7575]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-264-AD; Amendment 39-12082; AD 2001-01-12]
RIN 2120-AA64


Airworthiness Directives; Construcciones Aeronauticas, S.A. 
(CASA), Model CN-235, CN-235-100, and CN-235-200 Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to to all CASA Model CN-235, CN-235-100, and CN-235-200 
series airplanes, that requires replacing the upper brackets in frames 
33, 34, and 35, with improved brackets that are more fatigue resistant, 
and reinforcing frame 35. The actions specified by this AD are intended 
to prevent fatigue cracking in the zone of the fittings connecting the 
fuselage to stiffener rods located in frames 33, 34, and 35, which 
could result in reduced structural integrity of the airplane. This 
action is intended to address the identified unsafe condition.

DATES: Effective February 28, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of February 28, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from Construcciones Aeronauticas, S.A., Getafe, Madrid, Spain. 
This information may be examined at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all CASA Model CN-235, CN-235-100, 
and CN-235-200 series airplanes was published in the Federal Register 
on October 30, 2000 (65 FR 64634). That action proposed to require 
replacing the upper brackets in frames 33, 34, and 35, with improved 
brackets that are more fatigue resistant, and reinforcing frame 35.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    The FAA has determined that air safety and the public interest 
require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 1 airplane of U.S. registry will be affected 
by this AD, that it will take approximately 80 work hours per airplane 
to accomplish the required actions, and that the average labor rate is 
$60 per work hour. Required parts will cost approximately $2,871 per 
airplane. Based on these figures, the cost impact of the AD on the U.S. 
operator of the one affected airplane is estimated to be $7,671.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2001-01-12  Construcciones Aeronauticas, S.A. (CASA): Amendment 39-
12082. Docket 2000-NM-264--AD.

    Applicability: All Model CN-235, CN-235-100, and CN-235-200 
series airplanes, certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent fatigue cracking in the zone of the fittings 
connecting the fuselage to stiffener rods located in frames 33, 34, 
and 35, which could result in reduced structural integrity of the 
airplane, accomplish the following:

Bracket Replacement

    (a) Prior to the accumulation of 25,000 total landings, replace 
the upper brackets in frames 33, 34, and 35, with improved brackets 
that are more fatigue resistant, and reinforce frame 35, in 
accordance with CASA Service Bulletin SB-235-53-48, dated December 
11, 1997.

[[Page 7576]]

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with CASA Service 
Bulletin SB-235-53-48, dated December 11, 1997. This incorporation 
by reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Construcciones Aeronauticas, S.A., Getafe, Madrid, 
Spain. Copies may be inspected at the FAA, Transport Airplane 
Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the 
Office of the Federal Register, 800 North Capitol Street, NW., suite 
700, Washington, DC.

    Note 3: The subject of this AD is addressed in Spanish 
airworthiness directive 02/2000, dated January 31, 2000.

Effective Date

    (e) This amendment becomes effective on February 28, 2001.

    Issued in Renton, Washington, on January 11, 2001.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-1661 Filed 1-23-01; 8:45 am]
BILLING CODE 4910-13-P