AD 2001-01-08

[Federal Register Volume 66, Number 12 (Thursday, January 18, 2001)]
[Rules and Regulations]
[Pages 4647-4649]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 01-1077]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 2000-NM-141-AD; Amendment 39-12078; AD 2001-01-08]
RIN 2120-AA64


Airworthiness Directives; BAE Systems (Operations) Limited 
(Jetstream) Model 4101 Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all BAE Systems (Operations) Limited (Jetstream) Model 
4101 airplanes, that requires inspection

[[Page 4648]]

for cracking of the mounting brackets of the hydraulic hand pump at the 
frame attachment flanges, replacement of any cracked bracket with a new 
bracket, replacement of all bolts and nuts with new bolts and nuts, and 
installation of a particular ``D'' packer. The actions specified by 
this AD are intended to prevent failure of these brackets, which could 
result in inability to extend the landing gear in an emergency 
situation where the main hydraulic system is lost. This action is 
intended to address the identified unsafe condition.

DATES: Effective February 22, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of February 22, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from British Aerospace Regional Aircraft American Support, 
13850 Mclearen Road, Herndon, Virginia 20171. This information may be 
examined at the Federal Aviation Administration (FAA), Transport 
Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, 
Washington; or at the Office of the Federal Register, 800 North Capitol 
Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all British Aerospace (Jetstream) 
Model 4101 airplanes was published in the Federal Register on October 
30, 2000 (65 FR 64629). That action proposed to require inspection for 
cracking of the mounting brackets of the hydraulic hand pump at the 
frame attachment flanges, replacement of any cracked bracket with a new 
bracket, replacement of all bolts and nuts with new bolts and nuts, and 
installation of a particular ``D'' packer.

Manufacturer Name Change

    The manufacturer name in the final rule has been changed from 
British Aerospace to BAE Systems (Operations) Limited to reflect the 
recent company name change.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were submitted in response 
to the proposal or the FAA's determination of the cost to the public.

Conclusion

    After careful review of the available data, the FAA has determined 
that air safety and the public interest require the adoption of the 
rule with the change described previously. The FAA has determined that 
this change will neither increase the economic burden on any operator 
nor increase the scope of the AD.

Cost Impact

    The FAA estimates that 59 airplanes of U.S. registry will be 
affected by this AD, that it will take approximately 4 work hours per 
airplane to accomplish the required actions, and that the average labor 
rate is $60 per work hour. Based on these figures, the cost impact of 
the AD on U.S. operators is estimated to be $14,160, or $240 per 
airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted. The cost impact figures discussed 
in AD rulemaking actions represent only the time necessary to perform 
the specific actions actually required by the AD. These figures 
typically do not include incidental costs, such as the time required to 
gain access and close up, planning time, or time necessitated by other 
administrative actions.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2001-01-08 BAE Systems (Operations) Limited [Formerly British 
Aerospace Regional Aircraft]: Amendment 39-12078. Docket 2000-NM-
141-AD.

    Applicability: All Model Jetstream 4101 airplanes, certificated 
in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent failure of the mounting brackets of the hydraulic 
hand pump at the frame attachment flanges, which could result in 
inability to extend the landing gear in an emergency situation where 
the main hydraulic system is lost, accomplish the following:

Inspection and Installation

    (a) Within 6 months after the effective date of this AD, perform 
a one-time dye penetrant inspection to detect cracking of the 
mounting brackets of the hydraulic hand pump at the frame attachment 
flanges, install ``D'' packers to the mounting brackets, and replace 
all bolts and nuts with new bolts and nuts, in accordance with the 
Accomplishment Instructions of Jetstream Service Bulletin J41-53-
046, dated March 15, 2000. If any cracked bracket is found during 
the

[[Page 4649]]

inspection, prior to further flight, replace it with a new bracket.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 
21.197 and 21.199) to operate the airplane to a location where the 
requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The actions shall be done in accordance with Jetstream 
Service Bulletin J41-53-046, dated March 15, 2000. This 
incorporation by reference was approved by the Director of the 
Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 
51. Copies may be obtained from British Aerospace Regional Aircraft 
American Support, 13850 Mclearen Road, Herndon, Virginia 20171. 
Copies may be inspected at the FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

    Note 3: The subject of this AD is addressed in British 
airworthiness directive 003-03-2000.

Effective Date

    (e) This amendment becomes effective on February 22, 2001.

    Issued in Renton, Washington, on January 8, 2001.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 01-1077 Filed 1-17-01; 8:45 am]
BILLING CODE 4910-13-U