AD 2000-26-01
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | Airbus Helicopters Deutschland GmbH | BO-105C | Airworthiness Directives; Eurocopter Deutschland GMBH Model BO-105CB-5 and BO- 105CBS-5 Helicopters |
Unsafe Condition
Fatigue failure of a tension-torsion (TT) strap, leading to loss of a main rotor blade and subsequent loss of control of the helicopter.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Before further flight, remove TT straps part number 2604067 (Bendix) or J17322-1 (Lord) from service or re-identify them as P/N 117-14110 or 117-14111. Create a component log card for each TT strap and determine its age and flight history. Remove any TT strap if its history cannot be determined. Before further flight, remove and replace any TT strap P/N 117-14110 or 117-14111 that has been in service for 120 months or accumulated 25,000 flights. Revise the Airworthiness Limitations Section of the maintenance manual to establish a life limit for these TT straps.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
Before further flight
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
Eurocopter Deutschland GMBH Model BO-105CB-5 and BO-105CBS-5 helicopters, certificated in any category.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
This amendment supersedes an existing airworthiness directive (AD) that applies to Eurocopter Deutschland GMBH (ECD) Model BO-105CB-5 and BO-105CBS-5 helicopters. That AD currently requires, before further flight, creating a component log card or equivalent record and determining the calendar age and number of flights on each tension- torsion (TT) strap. This amendment requires before further flight, establishing a life limit for certain main rotor TT straps. This amendment is prompted by a need to establish a life limit for certain TT straps because of an accident in which a main rotor blade (blade) separated from an ECD Model MBB-BK 117 helicopter due to fatigue failure of a TT strap. The same part-numbered TT strap is used on the ECD Model BO-105 helicopters. The actions specified by this AD are intended to prevent fatigue failure of a TT strap, loss of a blade, and subsequent loss of control of the helicopter.
Document Text
Show stored source text (verify against official source)
[Federal Register Volume 65, Number 247 (Friday, December 22, 2000)]
[Rules and Regulations]
[Pages 80742-80743]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 00-32552]
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 99-SW-65-AD; Amendment 39-12048; AD 2000-26-01]
RIN 2120-AA64
Airworthiness Directives; Eurocopter Deutschland GMBH Model BO-
105CB-5 and BO-105CBS-5 Helicopters
AGENCY: Federal Aviation Administration, DOT.
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This amendment supersedes an existing airworthiness directive
(AD) that applies to Eurocopter Deutschland GMBH (ECD) Model BO-105CB-5
and BO-105CBS-5 helicopters. That AD currently requires, before further
flight, creating a component log card or equivalent record and
determining the calendar age and number of flights on each tension-
torsion (TT) strap. This amendment requires before further flight,
establishing a life limit for certain main rotor TT straps. This
amendment is prompted by a need to establish a life limit for certain
TT straps because of an accident in which a main rotor blade (blade)
separated from an ECD Model MBB-BK 117 helicopter due to fatigue
failure of a TT strap. The same part-numbered TT strap is used on the
ECD Model BO-105 helicopters. The actions specified by this AD are
intended to prevent fatigue failure of a TT strap, loss of a blade, and
subsequent loss of control of the helicopter.
DATES: Effective January 26, 2001.
The incorporation by reference of certain publications listed in
the regulations is approved by the Director of the Federal Register as
of January 26, 2001.
ADDRESSES: The service information referenced in this AD may be
obtained from American Eurocopter Corporation, 2701 Forum Drive, Grand
Prairie, Texas 75053-4005, telephone (972) 641-3460, fax (972) 641-
3527. This information may be examined at the FAA, Office of the
Regional Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort
Worth, Texas; or at the Office of the Federal Register, 800 North
Capitol Street, NW., suite 700, Washington, DC.
FOR FURTHER INFORMATION CONTACT: Charles Harrison, Aviation Safety
Engineer, FAA, Rotorcraft Directorate, Rotorcraft Standards Staff, Fort
Worth, Texas 76193-0110, telephone (817) 222-5128, fax (817) 222-5961.
SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal
Aviation Regulations (14 CFR part 39) by superseding AD 99-24-05,
Amendment 39-11429 (64 FR 62973, November 18, 1999), applicable to ECD
Model BO-105CB-5 and BO-105CBS-5 helicopters, was published in the
Federal Register on March 13, 2000 (65 FR 13251). That action proposed
to require establishing a life limit effective January 1, 2001, for the
TT straps of 120 months or 25,000 flights, whichever occurs first.
After the issuance of that Notice of Proposed Rulemaking (NPRM),
the FAA reevaluated the proposed requirements and determined that
establishing a life limit on the TT straps should be accomplished
before further flight and not by January 1, 2001, as earlier indicated.
The FAA also determined that the graduated inspection criteria and the
accompanying TT strap life limits specified in the current AD are no
longer necessary if the proposed life limit is established.
Since those changes expanded the scope of the original NPRM, the
FAA determined that it was necessary to reopen the comment period to
provide additional opportunity for public comment and published a
Supplemental NPRM (SNPRM) on September 20, 2000 (65 FR 56817). The
SNPRM revised the NPRM by proposing to require that you establish a
life limit for certain main rotor TT straps before further flight
instead of by January 1, 2001, as indicated in the previous proposal.
The SNPRM also proposed removing some of the requirements that were
proposed previously.
Interested persons have been afforded an opportunity to participate
in the making of this amendment. No comments were received on the
proposal or the FAA's determination of the cost to the public. The FAA
has determined that air safety and the public interest require the
adoption of the rule as proposed.
The FAA estimates that 200 helicopters of U.S. registry will be
affected by this AD, that it will take approximately 16 work hours per
helicopter to accomplish the required actions, and that the average
labor rate is $60 per work hour. Required parts will cost approximately
$10,400 per helicopter. Based on these figures, the total cost impact
of the AD on U.S. operators is estimated to be $2,272,200.
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
Government and the States, or on the distribution of power and
responsibilities among the various
[[Page 80743]]
levels of government. Therefore, it is determined that this final rule
does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. A final evaluation has been prepared for this action
and it is contained in the Rules Docket. A copy of it may be obtained
from the Rules Docket at the location provided under the caption
ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Incorporation by
reference, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by removing Amendment 39-11429 (64 FR
62973, November 18, 1999), and by adding a new airworthiness directive
(AD), Amendment 39-12048, to read as follows:
2000-26-01 Eurocopter Deutschland GMBH: Amendment 39-12048. Docket
No. 99-SW-65-AD. Supersedes AD 99-24-05, Amendment 39-11429, Docket
No. 99-SW-58--AD.
Applicability: Model BO-105 CB-5, and BO-105CBS-5 helicopters,
certificated in any category.
Note 1: This AD applies to each helicopter identified in the
preceding applicability provision, regardless of whether it has been
otherwise modified, altered, or repaired in the area subject to the
requirements of this AD. For helicopters that have been modified,
altered, or repaired so that the performance of the requirements of
this AD is affected, the owner/operator must request approval for an
alternative method of compliance in accordance with paragraph (d) of
this AD. The request should include an assessment of the effect of
the modification, alteration, or repair on the unsafe condition
addressed by this AD; and if the unsafe condition has not been
eliminated, the request should include specific proposed actions to
address it.
Compliance: Required as indicated, unless accomplished
previously.
To prevent fatigue failure of a tension-torsion (TT) strap, loss
of a main rotor blade (blade), and subsequent loss of control of the
helicopter, accomplish the following:
(a) Before further flight:
(1) Remove TT straps, part number (P/N) 2604067 (Bendix) or
J17322-1 (Lord), from service or re-identify them as P/N 117-14110
or 117-14111, respectively, in accordance with the Accomplishment
Instructions, paragraph 2.B.1.2., Eurocopter Deutschland GMBH Alert
Service Bulletin BO 105 No. ASB-BO 105-10-113, Revision 2, dated
November 16, 1999 (ASB). TT straps, P/N 2604067 (Bendix) or J17322-1
(Lord), are no longer eligible for installation.
(2) Create a component log card or equivalent record for each TT
strap.
(3) Review the history of the helicopter and each TT strap.
Determine the age since initial installation on any helicopter (age)
and the number of flights on each TT strap. Enter both the age and
the number of flights for each TT strap on the component log card or
equivalent record. When the number of flights is unknown, multiply
the number of hours time-in-service (TIS) by 5 to determine the
number of flights.
(4) Remove any TT strap from service if the total hours TIS or
number of flights and age cannot be determined.
(b) Before further flight, remove any TT strap, P/N 117-14110 or
117-14111, that has been in service 120 months since initial
installation on any helicopter or accumulated 25,000 flights (a
flight is a takeoff and a landing). Replace the TT strap with an
airworthy TT strap.
(c) This AD revises the Airworthiness Limitations Section of the
maintenance manual by establishing a life limit for the TT strap, P/
N 117-14110 and 117-14111, of 120 months or 25,000 flights,
whichever occurs first.
(d) An alternative method of compliance or adjustment of the
compliance time that provides an acceptable level of safety may be
used if approved by the Manager, Regulations Group, Rotorcraft
Directorate, FAA. Operators shall submit their requests through an
FAA Principal Maintenance Inspector, who may concur or comment and
then send it to the Manager, Regulations Group.
Note 2: Information concerning the existence of approved
alternative methods of compliance with this AD, if any, may be
obtained from the Regulations Group.
(e) Special flight permits may be issued in accordance with
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate the helicopter to a location where
the requirements of this AD can be accomplished.
(f) The modification shall be done in accordance with the
Accomplishment Instructions, paragraph 2.B.1.2., Eurocopter
Deutschland GMBH Alert Service Bulletin BO 105 No. ASB-BO 105-10-
113, Revision 2, dated November 16, 1999. This incorporation by
reference was approved by the Director of the Federal Register in
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be
obtained from American Eurocopter Corporation, 2701 Forum Drive,
Grand Prairie, Texas 75053-4005, telephone (972) 641-3460, fax (972)
641-3527. Copies may be inspected at the FAA, Office of the Regional
Counsel, Southwest Region, 2601 Meacham Blvd., Room 663, Fort Worth,
Texas; or at the Office of the Federal Register, 800 North Capitol
Street, NW., suite 700, Washington, DC.
(g) This amendment becomes effective on January 26, 2001.
Note 3: The subject of this AD is addressed in the Luftfahrt
Bundesamt (Federal Republic of Germany) AD 1999-289/2, dated
September 1, 1999.
Issued in Fort Worth, Texas, on December 11, 2000.
Henry A. Armstrong,
Manager, Rotorcraft Directorate, Aircraft Certification Service.
[FR Doc. 00-32552 Filed 12-21-00; 8:45 am]
BILLING CODE 4910-13-U
Source: Official FAA Source ↗
Retrieved: Apr 6, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.