AD 2000-23-26

final rule

Airworthiness Directives; Aerospatiale Model ATR72 Series Airplanes

AD Number
2000-23-26
Status
final_rule
Effective Date
Product Category
aircraft
Docket
Docket No. 97-NM-273-AD
FR Citation
65 FR 70775

Applicability

TypeManufacturerModelDetails
aircraft Aerospatiale ATR72 Airworthiness Directives; Aerospatiale Model ATR72 Series Airplanes

Unsafe Condition

Fatigue cracking in certain structural elements could adversely affect the structural integrity of these airplanes.

AI-generated summary from the source AD text. Verify against the official source before acting.

Required Actions

Revise the Airworthiness Limitations Section of the Instructions for Continued Airworthiness by incorporating the 'Time Limits' section of the ATR72 Maintenance Planning Document, Revision 4, dated July 1999. No alternative inspections or intervals may be approved for the specified structural elements unless an alternative method of compliance is approved.

AI-generated summary from the source AD text. Verify against the official source before acting.

Compliance Time

Within 30 days after the effective date of this AD.

AI-generated summary from the source AD text. Verify against the official source before acting.

Affected Aircraft

All Aerospatiale Model ATR72 series airplanes, certificated in any category.

AI-generated summary from the source AD text. Verify against the official source before acting.

Federal Register Abstract

This amendment adopts a new airworthiness directive (AD), applicable to all Aerospatiale Model ATR72 series airplanes, that requires a revision to the Airworthiness Limitations Section of the Instructions for Continued Airworthiness to incorporate inspections to detect fatigue cracking in certain structure, inspection intervals, and life limits for certain components. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to ensure that fatigue cracking of certain structural elements is detected and corrected; such fatigue cracking could adversely affect the structural integrity of these airplanes.

Document Text

Show stored source text (verify against official source)
[Federal Register Volume 65, Number 229 (Tuesday, November 28, 2000)]
[Rules and Regulations]
[Pages 70775-70777]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 00-29607]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 97-NM-273-AD; Amendment 39-11999; AD 2000-23-26]
RIN 2120-AA64


Airworthiness Directives; Aerospatiale Model ATR72 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to all Aerospatiale Model ATR72 series airplanes, that 
requires a revision to the Airworthiness Limitations Section of the 
Instructions for Continued Airworthiness to incorporate inspections to 
detect fatigue cracking in certain structure, inspection intervals, and 
life limits for certain components. This amendment is prompted by 
issuance of mandatory continuing airworthiness information by a foreign 
civil airworthiness authority. The actions specified by this AD are 
intended to ensure that fatigue cracking of certain structural elements 
is detected and corrected; such fatigue cracking

[[Page 70776]]

could adversely affect the structural integrity of these airplanes.

DATES: Effective January 2, 2001.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of January 2, 2001.

ADDRESSES: The service information referenced in this AD may be 
obtained from Aerospatiale, 316 Route de Bayonne, 31060 Toulouse, Cedex 
03, France. This information may be examined at the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, Rules Docket, 
1601 Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, Washington, 
DC.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to all Aerospatiale Model ATR72 
series airplanes was published as a supplemental notice of proposed 
rulemaking (NPRM) in the Federal Register on August 23, 2000 (65 FR 
51260). That action proposed to require a revision to the Airworthiness 
Limitations Section of the Instructions for Continued Airworthiness to 
incorporate inspections to detect fatigue cracking in certain 
structure, inspection intervals, and life limits for certain 
components.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. No comments were received in response 
to the supplemental NPRM.

Conclusion

    After careful review of the available data, including the comments 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    The FAA estimates that 39 Aerospatiale Model ATR72 series airplanes 
of U.S. registry will be affected by this AD, that it will take 
approximately 1 work hour per airplane to accomplish the required 
actions, and that the average labor rate is $60 per work hour. Based on 
these figures, the cost impact of the AD on U.S. operators is estimated 
to be $2,340, or $60 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2000-23-26  Aerospatiale: Amendment 39-11999. Docket 97-NM-273-AD.

    Applicability: All Model ATR72 series airplanes, certificated in 
any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (c) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To ensure continued structural integrity of these airplanes, 
accomplish the following:

Airworthiness Limitations Revision

    (a) Within 30 days after the effective date of this AD, revise 
the Airworthiness Limitations Section of the Instructions for 
Continued Airworthiness by incorporating the ``Time Limits'' section 
of the ATR72 Maintenance Planning Document, Revision 4, dated July 
1999, into the Airworthiness Limitations Section.
    (b) Except as provided in paragraph (c) of this AD: After the 
actions specified in paragraph (a) of this AD have been 
accomplished, no alternative inspections or inspection intervals may 
be approved for the structural elements specified in the documents 
listed in paragraph (a) of this AD.

Alternative Methods of Compliance

    (c) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

Special Flight Permits

    (d) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

Incorporation by Reference

    (e) The Airworthiness Limitations revision shall be done in 
accordance with the ``Time Limits'' section of the ATR72 Maintenance 
Planning Document, Revision 4, dated July 1999. This incorporation 
by reference was approved by the Director of the Federal Register in 
accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be 
obtained from Aerospatiale, 316 Route de Bayonne, 31060 Toulouse, 
Cedex 03, France. Copies

[[Page 70777]]

may be inspected at the FAA, Transport Airplane Directorate, 1601 
Lind Avenue, SW., Renton, Washington; or at the Office of the 
Federal Register, 800 North Capitol Street, NW., suite 700, 
Washington, DC.

    Note 3: The subject of this AD is addressed in French 
airworthiness directive 95-105-026 (B), dated May 24, 1995.

Effective Date

    (f) This amendment becomes effective on January 2, 2001.

    Issued in Renton, Washington, on November 14, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-29607 Filed 11-27-00; 8:45 am]
BILLING CODE 4910-13-P

Source: Official FAA Source ↗

Retrieved: Apr 6, 2026

Rights: U.S. Government Public Domain

This site is not affiliated with or endorsed by the FAA. Always verify with official sources.