AD 2000-03-18
Applicability
| Type | Manufacturer | Model | Details |
|---|---|---|---|
| aircraft | Vulcanair S.p.A. | AP68 TP Series 300 Spartacus | Airworthiness Directives; Partenavia Costruzioni Aeronauticas S.p.A. Models AP68TP 300 Spartacus" and AP68TP 600 "Viator" Airplanes |
| aircraft | Vulcanair S.p.A. | AP68TP 600 Viator | Airworthiness Directives; Partenavia Costruzioni Aeronauticas S.p.A. Models AP68TP 300 Spartacus" and AP68TP 600 "Viator" Airplanes |
Unsafe Condition
Reports of in-flight incidents and an accident in icing conditions where the airframe pneumatic deicing boots were not activated, leading to reduced controllability due to ice accumulation.
AI-generated summary from the source AD text. Verify against the official source before acting.
Required Actions
Revise the Airplane Flight Manual (AFM) to include requirements for activating the airframe pneumatic deicing boots at the first signs of ice accumulation.
AI-generated summary from the source AD text. Verify against the official source before acting.
Compliance Time
Before further flight.
AI-generated summary from the source AD text. Verify against the official source before acting.
Affected Aircraft
Partenavia Costruzioni Aeronauticas S.p.A. Models AP68TP 300 'Spartacus' and AP68TP 600 'Viator' airplanes equipped with pneumatic deicing boots.
AI-generated summary from the source AD text. Verify against the official source before acting.
Federal Register Abstract
This document adopts a new airworthiness directive (AD) that applies to all Partenavia Costruzioni Aeronauticas S.p.A. (Partenavia) Models AP68TP 300 "Spartacus" and AP68TP 600 "Viator" airplanes that are equipped with pneumatic deicing boots. This AD requires you to revise the Airplane Flight Manual (AFM) to include requirements for activating the airframe pneumatic deicing boots. This AD is the result of reports of in-flight incidents and an accident that occurred in icing conditions where the airframe pneumatic deicing boots were not activated. The actions specified by this AD are intended to assure that flightcrews have the information necessary to activate the pneumatic wing and tail deicing boots at the first signs of ice accumulation. Without this information, flightcrews could experience reduced controllability of the aircraft due to adverse aerodynamic effects of ice adhering to the airplane prior to the first deicing cycle.
Document Text
Show stored source text (verify against official source)
[Federal Register Volume 65, Number 32 (Wednesday, February 16, 2000)]
[Rules and Regulations]
[Pages 7716-7717]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 00-3624]
=======================================================================
-----------------------------------------------------------------------
DEPARTMENT OF TRANSPORTATION
Federal Aviation Administration
14 CFR Part 39
[Docket No. 99-CE-37-AD; Amendment 39-11577; AD 2000-03-18]
RIN 2120-AA64
Airworthiness Directives; Partenavia Costruzioni Aeronauticas
S.p.A. Models AP68TP 300 ``Spartacus'' and AP68TP 600 ``Viator''
Airplanes
ACTION: Final rule.
-----------------------------------------------------------------------
SUMMARY: This document adopts a new airworthiness directive (AD) that
applies to all Partenavia Costruzioni Aeronauticas S.p.A. (Partenavia)
Models AP68TP 300 ``Spartacus'' and AP68TP 600 ``Viator'' airplanes
that are equipped with pneumatic deicing boots. This AD requires you to
revise the Airplane Flight Manual (AFM) to include requirements for
activating the airframe pneumatic deicing boots. This AD is the result
of reports of in-flight incidents and an accident that occurred in
icing conditions where the airframe pneumatic deicing boots were not
activated. The actions specified by this AD are intended to assure that
flightcrews have the information necessary to activate the pneumatic
wing and tail deicing boots at the first signs of ice accumulation.
Without this information, flightcrews could experience reduced
controllability of the aircraft due to adverse aerodynamic effects of
ice adhering to the airplane prior to the first deicing cycle.
DATES: Effective April 7, 2000.
ADDRESSES: You may examine related information at the Federal Aviation
Administration (FAA), Central Region, Office of the Regional Counsel,
Attention: Rules Docket No. 99-CE-37-AD, 901 Locust, Room 506, Kansas
City, Missouri 64106.
FOR FURTHER INFORMATION CONTACT: Mr. John P. Dow, Sr., Aerospace
Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas
City, Missouri 64106; telephone: (816) 329-4121; facsimile: (816) 329-
4090.
SUPPLEMENTARY INFORMATION:
Events Leading to the Issuance of This AD
What caused this AD? This AD is the result of reports of in-flight
incidents and an accident that occurred in icing conditions where the
airframe pneumatic deicing boots were not activated.
What is the potential impact if the FAA took no action? The
information necessary to activate the pneumatic wing and tail deicing
boots at the first signs of ice accumulation is critical for flight in
icing conditions. If we did not take action to include this
information, flight crews could experience reduced controllability of
the aircraft due to adverse aerodynamic effects of ice adhering to the
airplane prior to the first deicing cycle.
Has the FAA taken any action to this point? Yes. We issued a
proposal to amend part 39 of the Federal Aviation Regulations (14 CFR
part 39) to include an AD that would apply to all Partenavia Models
AP68TP 300 ``Spartacus'' and AP68TP 600 ``Viator'' airplanes that are
equipped with pneumatic deicing boots. This proposal was published in
the Federal Register as a notice of proposed rulemaking (NPRM) on
October 8, 1999 (64 FR 54808). The NPRM proposed to require revising
the Limitations Section of the AFM to include requirements for
activating the pneumatic deicing boots at the first indication of ice
accumulation on the airplane.
Was the public invited to comment? Yes. Interested persons were
afforded an opportunity to participate in the making of this amendment.
No comments were received on the proposed rule or the FAA's
determination of the cost to the public.
What is the FAA's Final Determination on this Issue?: We carefully
reviewed all available information related to the subject presented
above and determined that air safety and the public interest require
the adoption of the rule as proposed except for minor editorial
corrections. We determined that these minor corrections:
--Will not change the meaning of the AD; and
--Will not add any additional burden upon the public than was already
proposed.
Cost Impact
How many airplanes does this AD impact?: We estimate that 3
airplanes in the U.S. registry will be affected.
What is the cost impact of the affected airplanes on the U.S.
Register?: There is no dollar cost impact. We estimate that to
accomplish the AFM revision it will take you less than 1 workhour. You
can accomplish this action if you hold at least a private pilot
certificate as authorized by section 43.7 of the Federal Aviation
Regulations (14 CFR 43.7). You must make an entry into the aircraft
records that shows compliance with this AD, in accordance with section
43.9 of the Federal Aviation Regulations (14 CFR 43.9). The only cost
impact of this AD is the time it will take you to insert the
information into the AFM.
Regulatory Impact
The regulations adopted herein will not have a substantial direct
effect on the States, on the relationship between the national
government and the States, or on the distribution of power and
responsibilities among the various levels of government. Therefore, it
is determined that this final rule does not have federalism
implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is
not a ``significant regulatory action'' under Executive Order 12866;
(2) is not a ``significant rule'' under DOT Regulatory Policies and
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a
significant economic impact, positive or negative, on a substantial
number of small entities under the criteria of the Regulatory
Flexibility Act. The FAA has prepared a final evaluation and placed it
in the Rules Docket. You can get a copy of this evaluation at the
location listed under the caption ADDRESSES.
List of Subjects in 14 CFR Part 39
Air transportation, Aircraft, Aviation safety, Safety.
Adoption of the Amendment
Accordingly, pursuant to the authority delegated to me by the
Administrator, the Federal Aviation Administration amends part 39 of
the Federal Aviation Regulations (14 CFR part 39) as follows:
PART 39--AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
Authority: 49 U.S.C. 106(g), 40113, 44701.
Sec. 39.13 [Amended]
2. Section 39.13 is amended by adding a new airworthiness directive
(AD) to read as follows:
2000-03-18 Partenavia Costruzioni Aeronautics S.P.A.:
Amendment 39-11577; Docket No. 99-CE-37-AD.
[[Page 7717]]
(a) What airplanes are affected by this AD? Models AP68TP 300
``Spartacus'' and AP68TP 600 ``Viator'' airplanes, all serial
numbers, that are:
(1) Equipped with pneumatic deicing boots; and
(2) Certificated in any category.
(b) Who must comply with this AD? Anyone who wishes to operate
any of the above airplanes on the U.S. Register. The AD does not
apply to your airplane if it is not equipped with pneumatic deicing
boots.
(c) What problem does this AD address? The information necessary
to activate the pneumatic wing and tail deicing boots at the first
signs of ice accumulation is critical for flight in icing
conditions. If we did not take action to include this information,
flight crews could experience reduced controllability of the
aircraft due to adverse aerodynamic effects of ice adhering to the
airplane prior to the first deicing cycle.
(d) What must I do to address this problem? To address this
problem, you must revise the Limitations Section of the FAA-approved
Airplane Flight Manual (AFM) to include the following requirements
for activation of the ice protection systems. You must accomplish
this action within the next 10 calendar days after the effective
date of this AD, unless already accomplished. You may insert a copy
of this AD in the AFM to accomplish this action:
``<bullet> Except for certain phases of flight where the AFM
specifies that deicing boots should not be used (e.g., take-off,
final approach, and landing), compliance with the following is
required.
<bullet> Wing and Tail Leading Edge Pneumatic Deicing Boot
System, if installed, must be activated:
--At the first sign of ice formation anywhere on the aircraft, or
upon annunciation from an ice detector system, whichever occurs
first; and
--The system must either be continued to be operated in the
automatic cycling mode, if available; or the system must be manually
cycled as needed to minimize the ice accretions on the airframe.
<bullet> The wing and tail leading edge pneumatic deicing boot
system may be deactivated only after leaving icing conditions and
after the airplane is determined to be clear of ice.''
(e) Can the pilot accomplish the action? Yes. Anyone who holds
at least a private pilot certificate, as authorized by section 43.7
of the Federal Aviation Regulations (14 CFR 43.7), may incorporate
the AFM revisions required by this AD. You must make an entry into
the aircraft records that shows compliance with this AD, in
accordance with section 43.9 of the Federal Aviation Regulations (14
CFR 43.9).
(f) Can I comply with this AD in any other way? Yes.
(1) You may use an alternative method of compliance or adjust
the compliance time if:
(i) Your alternative method of compliance provides an equivalent
level of safety; and
(ii) The Manager, Small Airplane Directorate, approves your
alternative. Submit your request through an FAA Principal
Maintenance Inspector, who may add comments and then send it to the
Manager.
(2) This AD applies to each airplane identified in the preceding
applicability provision, regardless of whether it has been modified,
altered, or repaired in the area subject to the requirements of this
AD. For airplanes that have been modified, altered, or repaired so
that the performance of the requirements of this AD is affected, the
owner/operator must request approval for an alternative method of
compliance in accordance with paragraph (f)(1) of this AD. The
request should include an assessment of the effect of the
modification, alteration, or repair on the unsafe condition
addressed by this AD; and, if you have not eliminated the unsafe
condition, specific actions you propose to address it.
(g) Where can I get information about any already-approved
alternative methods of compliance? Contact the Small Airplane
Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106;
telephone: (816) 329-4121; facsimile: (816) 329-4091.
(h) What if I need to fly the airplane to another location to
comply with this AD? The FAA can issue a special flight permit under
sections 21.197 and 21.199 of the Federal Aviation Regulations (14
CFR 21.197 and 21.199) to operate your airplane to a location where
you can accomplish the requirements of this AD.
(i) When does this amendment become effective? This amendment
becomes effective on April 7, 2000.
Issued in Kansas City, Missouri, on February 8, 2000.
Michael K. Dahl,
Acting Manager, Small Airplane Directorate, Aircraft Certification
Service.
[FR Doc. 00-3624 Filed 2-15-00; 8:45 am]
BILLING CODE 4910-13-P
Source: Official FAA Source ↗
Retrieved: Apr 6, 2026
Rights: U.S. Government Public Domain
This site is not affiliated with or endorsed by the FAA. Always verify with official sources.