AD 2000-03-12

final rule

Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes

AD Number
2000-03-12
Status
final_rule
Effective Date
Product Category
aircraft
Docket
Docket No. 99-NM-170-AD
FR Citation
65 FR 8030
Technical illustration of an aircraft electrical generator and wiring assembly
Problem area Electrical system

Applicability

TypeManufacturerModelDetails
aircraft McDonnell Douglas MD-11 Airworthiness Directives; McDonnell Douglas Model MD-11 Series Airplanes

Unsafe Condition

Loose terminal attachment hardware on the air driven generator (ADG) power monitor relay due to stress on the terminal attachment points.

AI-generated summary from the source AD text. Verify against the official source before acting.

Required Actions

Replace the ADG wire assembly with a new, increased length wire assembly.

AI-generated summary from the source AD text. Verify against the official source before acting.

Compliance Time

Before further flight.

AI-generated summary from the source AD text. Verify against the official source before acting.

Affected Aircraft

McDonnell Douglas Model MD-11 series airplanes.

AI-generated summary from the source AD text. Verify against the official source before acting.

Federal Register Abstract

This amendment adopts a new airworthiness directive (AD), applicable to certain McDonnell Douglas Model MD-11 series airplanes, that requires replacement of the air driven generator (ADG) wire assembly with a new, increased length wire assembly. This amendment is prompted by a report of loose terminal attachment hardware on the ADG power monitor relay due to a stress condition on the terminal attachment points. The actions specified by this AD are intended to prevent loss of the charging capability of the aircraft battery. Loss of the charging capability of the aircraft battery, coupled with a loss of all normal electrical power, could prevent continued safe flight and landing of the airplane.

Document Text

Show stored source text (verify against official source)
[Federal Register Volume 65, Number 33 (Thursday, February 17, 2000)]
[Rules and Regulations]
[Pages 8030-8031]
From the Federal Register Online via the Government Publishing Office [<a href="http://www.gpo.gov">www.gpo.gov</a>]
[FR Doc No: 00-3618]



[[Page 8030]]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 99-NM-170-AD; Amendment 39-11571; AD 2000-03-12]
RIN 2120-AA64


Airworthiness Directives; McDonnell Douglas Model MD-11 Series 
Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Final rule.

-----------------------------------------------------------------------

SUMMARY: This amendment adopts a new airworthiness directive (AD), 
applicable to certain McDonnell Douglas Model MD-11 series airplanes, 
that requires replacement of the air driven generator (ADG) wire 
assembly with a new, increased length wire assembly. This amendment is 
prompted by a report of loose terminal attachment hardware on the ADG 
power monitor relay due to a stress condition on the terminal 
attachment points. The actions specified by this AD are intended to 
prevent loss of the charging capability of the aircraft battery. Loss 
of the charging capability of the aircraft battery, coupled with a loss 
of all normal electrical power, could prevent continued safe flight and 
landing of the airplane.

DATES: Effective March 23, 2000.
    The incorporation by reference of certain publications listed in 
the regulations is approved by the Director of the Federal Register as 
of March 23, 2000.

ADDRESSES: The service information referenced in this AD may be 
obtained from Boeing Commercial Aircraft Group, Long Beach Division, 
3855 Lakewood Boulevard, Long Beach, CA 90846, Attention: Technical 
Publications Business Administration, Dept. C1-L51 (2-60). This 
information may be examined at the Federal Aviation Administration 
(FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, 
SW., Renton, WA; or at the FAA, Transport Airplane Directorate, Los 
Angeles Aircraft Certification Office, 3960 Paramount Boulevard, 
Lakewood, CA; or at the Office of the Federal Register, 800 North 
Capitol Street, NW., suite 700, Washington, DC.

FOR FURTHER INFORMATION CONTACT: Brett Portwood, Aerospace Engineer, 
Systems and Equipment Branch, ANM-130L, FAA, Transport Airplane 
Directorate, Los Angeles Aircraft Certification Office, 3960 Paramount 
Boulevard, Lakewood, CA 90712-4137; telephone (562) 627-5350; fax (562) 
627-5210.

SUPPLEMENTARY INFORMATION: A proposal to amend part 39 of the Federal 
Aviation Regulations (14 CFR part 39) to include an airworthiness 
directive (AD) that is applicable to certain McDonnell Douglas Model 
MD-11 series airplanes was published in the Federal Register on October 
27, 1999 (64 FR 57822). That action proposed to require replacement of 
the air driven generator (ADG) wire assembly with a new, increased 
length wire assembly.

Comments

    Interested persons have been afforded an opportunity to participate 
in the making of this amendment. Due consideration has been given to 
the single comment received.
    The commenter supports the proposed rule.

Conclusion

    After careful review of the available data, including the comment 
noted above, the FAA has determined that air safety and the public 
interest require the adoption of the rule as proposed.

Cost Impact

    There are approximately 180 airplanes of the affected design in the 
worldwide fleet. The FAA estimates that 60 airplanes of U.S. registry 
will be affected by this AD, that it will take approximately 1 work 
hour per airplane to accomplish the required replacement, and that the 
average labor rate is $60 per work hour. Required parts will cost 
approximately $786 per airplane. Based on these figures, the cost 
impact of the AD on U.S. operators is estimated to be $50,760, or $846 
per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the requirements of this AD 
action, and that no operator would accomplish those actions in the 
future if this AD were not adopted.

Regulatory Impact

    The regulations adopted herein will not have a substantial direct 
effect on the States, on the relationship between the national 
Government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, it 
is determined that this final rule does not have federalism 
implications under Executive Order 13132.
    For the reasons discussed above, I certify that this action (1) is 
not a ``significant regulatory action'' under Executive Order 12866; 
(2) is not a ``significant rule'' under DOT Regulatory Policies and 
Procedures (44 FR 11034, February 26, 1979); and (3) will not have a 
significant economic impact, positive or negative, on a substantial 
number of small entities under the criteria of the Regulatory 
Flexibility Act. A final evaluation has been prepared for this action 
and it is contained in the Rules Docket. A copy of it may be obtained 
from the Rules Docket at the location provided under the caption 
ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Incorporation by 
reference, Safety.

Adoption of the Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration amends part 39 of 
the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

2000-03-12  McDonnell Douglas: Amendment 39-11571. Docket 99-NM-170-
AD.

    Applicability: Model MD-11 series airplanes, as listed in 
McDonnell Douglas Service Bulletin MD11-24-128, Revision 1, dated 
July 30, 1999; certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent loss of the charging capability of the air driven 
generator (ADG), that when coupled with a loss of all normal 
electrical power, could prevent continued safe flight and landing of 
the airplane, accomplish the following:

[[Page 8031]]

Replacement

    (a) Within 1 year after the effective date of this AD, replace 
the ADG wire assembly, part number (P/N) ACS9006-501, with a new, 
increased length wire assembly, P/N ACS9006-502, in accordance with 
McDonnell Douglas Service Bulletin MD11-24-128, dated September 17, 
1998, or Revision 1, dated July 30, 1999.

Alternative Methods of Compliance

    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, Los Angeles Aircraft Certification 
Office (ACO), FAA, Transport Airplane Directorate. Operators shall 
submit their requests through an appropriate FAA Principal 
Maintenance Inspector, who may add comments and then send it to the 
Manager, Los Angeles ACO.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the Los Angeles ACO.

Special Flight Permits

    (c) Special flight permits may be issued in accordance with 
Secs. 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 
21.197 and 21.199) to operate the airplane to a location where the 
requirements of this AD can be accomplished.

Incorporation by Reference

    (d) The replacement shall be done in accordance with McDonnell 
Douglas
Service Bulletin MD11-24-128, dated September 17, 1998, or McDonnell 
Douglas Service Bulletin MD11-24-128, Revision 01, dated July 30, 
1999. This incorporation by reference was approved by the Director 
of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR 
part 51. Copies may be obtained from Boeing Commercial Aircraft 
Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, CA 
90846, Attention: Technical Publications Business Administration, 
Dept. C1-L51 (2-60). Copies may be inspected at the FAA, Transport 
Airplane Directorate, 1601 Lind Avenue, SW., Renton, WA; or at the 
FAA, Transport Airplane Directorate, Los Angeles Aircraft 
Certification Office, 3960 Paramount Boulevard, Lakewood, CA; or at 
the Office of the Federal Register, 800 North Capitol Street, NW., 
suite 700, Washington, DC.
    (e) This amendment becomes effective on March 23, 2000.

    Issued in Renton, Washington, on February 10, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 00-3618 Filed 2-16-00; 8:45 am]
BILLING CODE 4910-13-P

Source: Official FAA Source ↗

Retrieved: Apr 6, 2026

Rights: U.S. Government Public Domain

This site is not affiliated with or endorsed by the FAA. Always verify with official sources.